2005-01-31 07:21:06

by Emmanuel Fleury

[permalink] [raw]
Subject: [Watchdog] alim7101_wdt problem on 2.6.10

Hi,

I have a Vaio C1MZX and in the lspci I saw this line:
0000:00:11.0 Non-VGA unclassified device: ALi Corporation M7101 Power
Management Controller [PMU]

So, I assumed it was a watchdog and I compiled with the option:
CONFIG_ALIM7101_WDT=m

But, when I do: modprobe alim7101_wdt

I get the following error message:

Jan 30 00:58:21 hermes vmunix: alim7101_wdt: Steve Hill
<[email protected]>.
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does
not have the correct revision number (???1001?) - WDT
not set

What did I do wrong ?

If some patches need to be tried out, I volunteer. :)

Thanks in advance for you reply
--
Emmanuel Fleury

Computer Science Department, | Office: B1-201
Aalborg University, | Phone: +45 96 35 72 23
Fredriks Bajersvej 7E, | Fax: +45 98 15 98 89
9220 Aalborg East, Denmark | Email: [email protected]


2005-01-31 07:32:34

by Tim Hockin

[permalink] [raw]
Subject: Re: [Watchdog] alim7101_wdt problem on 2.6.10

On Mon, Jan 31, 2005 at 08:22:11AM +0100, Emmanuel Fleury wrote:
> Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does
> not have the correct revision number (???1001?) - WDT
> not set
>
> What did I do wrong ?

You used the wrong South Bridge revision. Seriously, older revisions of
M7101 did not have a WDT. You seem to have an older revision. Sorry.

2005-01-31 18:56:37

by Mike Waychison

[permalink] [raw]
Subject: Re: [Watchdog] alim7101_wdt problem on 2.6.10

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Tim Hockin wrote:
> On Mon, Jan 31, 2005 at 08:22:11AM +0100, Emmanuel Fleury wrote:
>
>>Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does
>>not have the correct revision number (???1001?) - WDT
>>not set
>>
>>What did I do wrong ?
>
>
> You used the wrong South Bridge revision. Seriously, older revisions of
> M7101 did not have a WDT. You seem to have an older revision. Sorry.
>

FWIW, some of the old cobalt boxes had the old south bridge revision
with a WDT. It managed to do resets/wdt off gpio pin 5 though, and
there is a patch in Alan's 2.6.10-ac tree that handles it.

Whether or not it will work with your vaio? Probably not, though I
guess it wouldn't hurt to try (modprobe alim7101_wdt use_gpio=1).

- --
Mike Waychison
Sun Microsystems, Inc.
1 (650) 352-5299 voice
1 (416) 202-8336 voice

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NOTICE: The opinions expressed in this email are held by me,
and may not represent the views of Sun Microsystems, Inc.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFB/n8/dQs4kOxk3/MRAg/HAJ4x+SdKXwNDsKrtBMS9xLYcYLYVigCdHBTk
CWSOMh5FZPmfrky713Avd4g=
=DMs9
-----END PGP SIGNATURE-----

2005-01-31 19:01:20

by Tim Hockin

[permalink] [raw]
Subject: Re: [Watchdog] alim7101_wdt problem on 2.6.10

On Mon, Jan 31, 2005 at 01:55:59PM -0500, Mike Waychison wrote:
> FWIW, some of the old cobalt boxes had the old south bridge revision
> with a WDT. It managed to do resets/wdt off gpio pin 5 though, and
> there is a patch in Alan's 2.6.10-ac tree that handles it.

The old Cobalts also had a PIC attached to act as a WDT. :)