Evenin' all,
I was testing out my spiffy new (to me) QuickCam Express webcam, pressed
^C to terminate the test, and got the GPF shown below. Kernel version
is 2.6.12.3 running on SLAMD64:
The driver specifics are:
quickcam: QuickCam USB camera found (driver version QuickCam USB 0.6.3
$Date: 2005/04/15 19:32:49 $)
quickcam: Kernel:2.6.13.1 bus:3 class:FF subclass:FF vendor:046D
product:0870
quickcam: Sensor HDCS-1020 detected
quickcam: Registered device: /dev/video1
usbcore: registered new driver quickcam
APIC error on CPU0: 40(40)
APIC error on CPU0: 40(40)
The message on the console after I pressed ^C:
general protection fault: 0000 [1] PREEMPT
The relevant extract from dmesg:
quickcam: Control URB error -2
general protection fault: 0000 [1] PREEMPT
CPU 0
Modules linked in: quickcam snd_pcm_oss snd_mixer_oss nfsd exportfs
lockd sunrpc md5 ipv6 eth1394 ohci1394 ieee1394 tulip bt878 tuner
tvaudio bttv video_buf firmware_class v4l2_common btcx_risc tveeprom
videodev snd_atiixp snd_ac97_codec audio snd_usb_audio snd_pcm snd_timer
snd_page_alloc snd_usb_lib snd_rawmidi snd_seq_device snd_hwdep snd
ehci_hcd usb_storage
Pid: 9603, comm: testquickcam Not tainted 2.6.13.1
RIP: 0010:[<ffffffff802fe1a7>] <ffffffff802fe1a7>{usb_kill_urb+39}
RSP: 0000:ffff810006977c58 EFLAGS: 00010202
RAX: 0001002b00152dea RBX: ffff81001360a200 RCX: 0000000000000002
RDX: 0000000000000000 RSI: 0000000000000002 RDI: ffff81001360a200
RBP: 0000000000000001 R08: 0000000000000001 R09: 0000000000000000
R10: ffff81001f8bbe08 R11: 0000000000000002 R12: ffff81000a8a82f0
R13: ffff81000a847938 R14: ffff81000b285cf8 R15: ffff810006dc9e58
FS: 00002aaaaadfbb00(0000) GS:ffffffff80540800(0000)
knlGS:00000000560f2180
CS: 0010 DS: 0000 ES: 0000 CR0: 000000008005003b
CR2: 00002aaaaab0f008 CR3: 000000001b024000 CR4: 00000000000006e0
Process testquickcam (pid: 9603, threadinfo ffff810006976000, task
ffff810006dc9880)
Stack: ffff81001ef27800 ffffffff802ff5f4 ffff81001ef27800 ffff81001ef27800
0000000000000000 ffffffff802ff937 0000000000000000
ffff810000000000 ffffffff00001388 ffff81000a8a8000
Call Trace:<ffffffff802ff5f4>{usb_disable_interface+52} <ffffffff802ff937>{usb_set_interface+327}
<ffffffff88202b70>{:quickcam:qc_isoc_stop+224} <ffffffff882048c4>{:quickcam:qc_v4l_close+68}
<ffffffff80177002>{__fput+178} <ffffffff801756ee>{filp_close+110}
<ffffffff80134813>{put_files_struct+115} <ffffffff801351d5>{do_exit+533}
<ffffffff8013d825>{__dequeue_signal+501} <ffffffff80135df8>{do_group_exit+280}
<ffffffff8013fa57>{get_signal_to_deliver+1575} <ffffffff8010de8f>{do_signal+159}
<ffffffff801495b0>{autoremove_wake_function+0} <ffffffff80175f24>{vfs_read+308}
<ffffffff8010eb3f>{sysret_signal+28} <ffffffff8010ee27>{ptregscall_common+103}
Code: 48 8b 40 58 48 85 c0 0f 84 3c 01 00 00 48 83 78 30 00 0f 84
RIP <ffffffff802fe1a7>{usb_kill_urb+39} RSP <ffff810006977c58>
<1>Fixing recursive fault but reboot is needed!
Is this a buggy driver? I can provide more information if need be.
Thanks,
Kurt
--
"I used to think that the brain was the most wonderful organ in my
body. Then I realized who was telling me this."
-- Emo Phillips
On Fri, Sep 23, 2005 at 12:32:01AM -0400, Kurt Wall wrote:
> Evenin' all,
>
> I was testing out my spiffy new (to me) QuickCam Express webcam, pressed
> ^C to terminate the test, and got the GPF shown below. Kernel version
> is 2.6.12.3 running on SLAMD64:
>
> The driver specifics are:
>
> quickcam: QuickCam USB camera found (driver version QuickCam USB 0.6.3 $Date: 2005/04/15 19:32:49 $)
> quickcam: Kernel:2.6.13.1 bus:3 class:FF subclass:FF vendor:046D product:0870
> quickcam: Sensor HDCS-1020 detected
> quickcam: Registered device: /dev/video1
I don't see this driver in the main kernel tree. Where did you get it
from?
thanks,
greg k-h
On Fri, Sep 23, 2005 at 05:57:25AM -0700, Greg KH took 25 lines to write:
> On Fri, Sep 23, 2005 at 12:32:01AM -0400, Kurt Wall wrote:
> >
> > I was testing out my spiffy new (to me) QuickCam Express webcam, pressed
> > ^C to terminate the test, and got the GPF shown below. Kernel version
> > is 2.6.12.3 running on SLAMD64:
> >
> > The driver specifics are:
> >
> > quickcam: QuickCam USB camera found (driver version QuickCam USB 0.6.3 $Date: 2005/04/15 19:32:49 $)
> > quickcam: Kernel:2.6.13.1 bus:3 class:FF subclass:FF vendor:046D product:0870
> > quickcam: Sensor HDCS-1020 detected
> > quickcam: Registered device: /dev/video1
>
> I don't see this driver in the main kernel tree. Where did you get it
> from?
http://qce-ga.sourceforge.net/
Now that I think about it, I suppose I shouldn't complain to LKML since
this driver isn't in the kernel. There's a list over there, too. Sorry
to waste everyone's time. Geez; think twice, post once.
Kurt
--
Be free and open and breezy! Enjoy! Things won't get any better so
get used to it.