[patch 4/6] s390: qeth :allow setting of attribute "route6" to "no_router".
From: Ursula Braun <[email protected]>
when setting route6 attribute back to no_router qeth does not
issue an IP ASSIST command to reset router value to no_router.
Once primary_router is set device stays in this mode.
Issue an IP ASSIST command when no_router is set in route6.
Device will be reset and thus will not longer run as a primary
router.
Signed-off-by: Frank Pavlic <[email protected]>
diffstat:
qeth_main.c | 5 -----
1 files changed, 5 deletions(-)
diff --git a/drivers/s390/net/qeth_main.c b/drivers/s390/net/qeth_main.c
index 69329ea..021cd5d 100644
--- a/drivers/s390/net/qeth_main.c
+++ b/drivers/s390/net/qeth_main.c
@@ -7339,11 +7339,6 @@ qeth_setrouting_v6(struct qeth_card *car
qeth_correct_routing_type(card, &card->options.route6.type,
QETH_PROT_IPV6);
- if ((card->options.route6.type == NO_ROUTER) ||
- ((card->info.type == QETH_CARD_TYPE_OSAE) &&
- (card->options.route6.type == MULTICAST_ROUTER) &&
- !qeth_is_supported6(card,IPA_OSA_MC_ROUTER)))
- return 0;
rc = qeth_send_setrouting(card, card->options.route6.type,
QETH_PROT_IPV6);
if (rc) {