From: Peter Oberparleiter <[email protected]>
[S390] cio: no path after machine check.
Devices enter no-path state after disabling a channel path
via the SE even though another path has been reenabled at the SE.
The devices are set into no-path state before triggering path
verification even though other paths may have become available.
To fix this trigger path verification before setting a device into
no-path state.
Signed-off-by: Peter Oberparleiter <[email protected]>
Signed-off-by: Martin Schwidefsky <[email protected]>
---
drivers/s390/cio/chsc.c | 4 ++--
1 files changed, 2 insertions(+), 2 deletions(-)
diff -urpN linux-2.6/drivers/s390/cio/chsc.c linux-2.6-patched/drivers/s390/cio/chsc.c
--- linux-2.6/drivers/s390/cio/chsc.c 2006-08-24 12:10:55.000000000 +0200
+++ linux-2.6-patched/drivers/s390/cio/chsc.c 2006-08-24 12:10:55.000000000 +0200
@@ -238,8 +238,6 @@ s390_subchannel_remove_chpid(struct devi
/* Check for single path devices. */
if (sch->schib.pmcw.pim == 0x80)
goto out_unreg;
- if (sch->vpm == mask)
- goto out_unreg;
if ((sch->schib.scsw.actl & SCSW_ACTL_DEVACT) &&
(sch->schib.scsw.actl & SCSW_ACTL_SCHACT) &&
@@ -258,6 +256,8 @@ s390_subchannel_remove_chpid(struct devi
/* trigger path verification. */
if (sch->driver && sch->driver->verify)
sch->driver->verify(&sch->dev);
+ else if (sch->vpm == mask)
+ goto out_unreg;
out_unlock:
spin_unlock_irq(&sch->lock);
return 0;