1. Rename saved_command_line into boot_command_line.
2. Set command_line as __initdata.
Signed-off-by: Alon Bar-Lev <[email protected]>
---
arch/arm26/kernel/setup.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
Index: linux-2.6.20-rc4-mm1/arch/arm26/kernel/setup.c
===================================================================
--- linux-2.6.20-rc4-mm1.orig/arch/arm26/kernel/setup.c
+++ linux-2.6.20-rc4-mm1/arch/arm26/kernel/setup.c
@@ -80,7 +80,7 @@ unsigned long phys_initrd_size __initdat
static struct meminfo meminfo __initdata = { 0, };
static struct proc_info_item proc_info;
static const char *machine_name;
-static char command_line[COMMAND_LINE_SIZE];
+static char __initdata command_line[COMMAND_LINE_SIZE];
static char default_command_line[COMMAND_LINE_SIZE] __initdata = CONFIG_CMDLINE;
@@ -492,8 +492,8 @@ void __init setup_arch(char **cmdline_p)
init_mm.end_data = (unsigned long) &_edata;
init_mm.brk = (unsigned long) &_end;
- memcpy(saved_command_line, from, COMMAND_LINE_SIZE);
- saved_command_line[COMMAND_LINE_SIZE-1] = '\0';
+ memcpy(boot_command_line, from, COMMAND_LINE_SIZE);
+ boot_command_line[COMMAND_LINE_SIZE-1] = '\0';
parse_cmdline(&meminfo, cmdline_p, from);
bootmem_init(&meminfo);
paging_init(&meminfo);
--