Hi,
the latest kernel does not power off my old laptop.
2.6.22 succeeded
2.6.23-rc8 failed
$ git bisect good
Bisecting: 0 revisions left to test after this
[626073132b381684c4983e0d911e9aceb32e2cbc] Assembly header and main routine for new x86 setup code
Which more info is needed?
Wolfgang
Wolfgang Erig wrote:
> Hi,
>
> the latest kernel does not power off my old laptop.
>
> 2.6.22 succeeded
> 2.6.23-rc8 failed
>
> $ git bisect good
> Bisecting: 0 revisions left to test after this
> [626073132b381684c4983e0d911e9aceb32e2cbc] Assembly header and main routine for new x86 setup code
>
> Which more info is needed?
>
A description of the system, your .config file, kernel messages (old and
new).
Also see http://marc.info/[email protected] for a highly
useful debugging step, especially if you can dump both before & after.
-hpa
Wolfgang Erig wrote:
> Hi,
>
> the latest kernel does not power off my old laptop.
>
> 2.6.22 succeeded
> 2.6.23-rc8 failed
>
> $ git bisect good
> Bisecting: 0 revisions left to test after this
> [626073132b381684c4983e0d911e9aceb32e2cbc] Assembly header and main routine for new x86 setup code
>
> Which more info is needed?
>
Okay, I just went back and looked at it... this particular checkin had
*zero* code impact (code not yet turned on), as did any of the checkins
immediately surrounding it.
Since your other email points to
f216cc3748a3a22c2b99390fddcdafa0583791a2, which is a *much* later
checkin, and which seems to actually have something to do with power
states, that the above is a red herring?
-hpa
On Fri, Sep 28, 2007 at 06:11:16PM -0700, H. Peter Anvin wrote:
> Wolfgang Erig wrote:
> > Hi,
> >
> > the latest kernel does not power off my old laptop.
> >
> > 2.6.22 succeeded
> > 2.6.23-rc8 failed
> >
> > $ git bisect good
> > Bisecting: 0 revisions left to test after this
> > [626073132b381684c4983e0d911e9aceb32e2cbc] Assembly header and main routine for new x86 setup code
> >
> > Which more info is needed?
> >
>
> A description of the system, your .config file, kernel messages (old and
> new).
Laptop (about 10 years old, runs perfectly with 2.6.22) from
Siemens Nixdorf, Mobile 710, Pentium MMX 166
$ lspci
00:00.0 Host bridge: Intel Corporation 430TX - 82439TX MTXC (rev 01)
00:01.0 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 01)
00:01.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
00:01.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01)
00:01.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 01)
00:06.0 VGA compatible controller: Chips and Technologies F65554 (rev c2)
00:14.0 CardBus bridge: Cirrus Logic PD 6832 PCMCIA/CardBus Ctrlr (rev c1)
00:14.1 CardBus bridge: Cirrus Logic PD 6832 PCMCIA/CardBus Ctrlr (rev c1)
The last kernel messages written from the screen:
----- good case -----
Deactivating swap...done.
Will now halt.
Shutdown: hda
Power down.
(power off)
I'm not absolutely shure about the messages because it runs very fast.
----- bad case -----
Deactivating swap...done.
Will now halt.
Shutdown: hda
System halted.
_ (blinking cursor)
.config is attached.
Thankyou,
Wolfgang