This patch converts cpqarray to use blk_end_request().
cpqarray is a little bit different from "normal" drivers.
cpqarray directly calls bio_endio() and disk_stat_add()
when completing request. But those can be replaced with
__end_that_request_first().
After the replacement, request completion procedures of
those drivers become like the following:
o end_that_request_first()
o add_disk_randomness()
o end_that_request_last()
This can be converted to blk_end_request() by following
the rule (b) mentioned in the patch subject
"[PATCH 01/28] blk_end_request: add new request completion interface".
Signed-off-by: Kiyoshi Ueda <[email protected]>
Signed-off-by: Jun'ichi Nomura <[email protected]>
---
drivers/block/cpqarray.c | 27 ++-------------------------
1 files changed, 2 insertions(+), 25 deletions(-)
Index: 2.6.24-rc3-mm2/drivers/block/cpqarray.c
===================================================================
--- 2.6.24-rc3-mm2.orig/drivers/block/cpqarray.c
+++ 2.6.24-rc3-mm2/drivers/block/cpqarray.c
@@ -167,7 +167,6 @@ static void start_io(ctlr_info_t *h);
static inline void addQ(cmdlist_t **Qptr, cmdlist_t *c);
static inline cmdlist_t *removeQ(cmdlist_t **Qptr, cmdlist_t *c);
-static inline void complete_buffers(struct bio *bio, int ok);
static inline void complete_command(cmdlist_t *cmd, int timeout);
static irqreturn_t do_ida_intr(int irq, void *dev_id);
@@ -980,19 +979,6 @@ static void start_io(ctlr_info_t *h)
}
}
-static inline void complete_buffers(struct bio *bio, int ok)
-{
- struct bio *xbh;
-
- while (bio) {
- xbh = bio->bi_next;
- bio->bi_next = NULL;
-
- bio_endio(bio, ok ? 0 : -EIO);
-
- bio = xbh;
- }
-}
/*
* Mark all buffers that cmd was responsible for
*/
@@ -1030,18 +1016,9 @@ static inline void complete_command(cmdl
pci_unmap_page(hba[cmd->ctlr]->pci_dev, cmd->req.sg[i].addr,
cmd->req.sg[i].size, ddir);
- complete_buffers(rq->bio, ok);
-
- if (blk_fs_request(rq)) {
- const int rw = rq_data_dir(rq);
-
- disk_stat_add(rq->rq_disk, sectors[rw], rq->nr_sectors);
- }
-
- add_disk_randomness(rq->rq_disk);
-
DBGPX(printk("Done with %p\n", rq););
- end_that_request_last(rq, ok ? 1 : -EIO);
+ if (__blk_end_request(rq, ok, blk_rq_bytes(rq)))
+ BUG();
}
/*