From: Ursula Braun <[email protected]>
If an asynchronous HiperSockets queue runs full, no further packet
can be sent. In this case the next initiative to give transmitted
skbs back to the stack is triggered only by a 10-seconds qdio timer.
This timer has been introduced for low multicast traffic scenarios
to guarantee freeing of skbs in a limited amount of time. For high
HiperSocket multicast traffic scenarios progress checking on the
outbound queue should be enforced by tasklet rescheduling.
Signed-off-by: Ursula Braun <[email protected]>
Signed-off-by: Martin Schwidefsky <[email protected]>
---
drivers/s390/cio/qdio.h | 8 ++++++++
drivers/s390/cio/qdio_main.c | 6 ++++++
2 files changed, 14 insertions(+)
Index: quilt-2.6/drivers/s390/cio/qdio.h
===================================================================
--- quilt-2.6.orig/drivers/s390/cio/qdio.h
+++ quilt-2.6/drivers/s390/cio/qdio.h
@@ -16,6 +16,14 @@
#define QDIO_BUSY_BIT_GIVE_UP 2000000 /* 2 seconds = eternity */
#define QDIO_INPUT_THRESHOLD 500 /* 500 microseconds */
+/*
+ * if an asynchronous HiperSockets queue runs full, the 10 seconds timer wait
+ * till next initiative to give transmitted skbs back to the stack is too long.
+ * Therefore polling is started in case of multicast queue is filled more
+ * than 50 percent.
+ */
+#define QDIO_IQDIO_POLL_LVL 65 /* HS multicast queue */
+
enum qdio_irq_states {
QDIO_IRQ_STATE_INACTIVE,
QDIO_IRQ_STATE_ESTABLISHED,
Index: quilt-2.6/drivers/s390/cio/qdio_main.c
===================================================================
--- quilt-2.6.orig/drivers/s390/cio/qdio_main.c
+++ quilt-2.6/drivers/s390/cio/qdio_main.c
@@ -851,6 +851,12 @@ static void __qdio_outbound_processing(s
if (queue_type(q) == QDIO_IQDIO_QFMT && !multicast_outbound(q))
return;
+ if ((queue_type(q) == QDIO_IQDIO_QFMT) &&
+ (atomic_read(&q->nr_buf_used)) > QDIO_IQDIO_POLL_LVL) {
+ tasklet_schedule(&q->tasklet);
+ return;
+ }
+
if (q->u.out.pci_out_enabled)
return;
--
blue skies,
Martin.
"Reality continues to ruin my life." - Calvin.