The support is implemented via platform data accessors, new module
(of_mmc_spi) will be created automatically when the driver compiles
on OpenFirmware platforms. Link-time dependency will load the module
automatically.
Signed-off-by: Anton Vorontsov <[email protected]>
---
Hello Pierre,
All the needed patches were merged into Linus' tree, so I believe
it's time for the bindings.
Note that you need to pull Linus' tree into mmc.git's next branch
before applying this patch, otherwise it will break bisect, since
of_mmc_spi isn't buildable without some patches that are in Linus'
tree, but not in the current mmc.git next.
Thanks,
drivers/mmc/host/Makefile | 3 +
drivers/mmc/host/mmc_spi.c | 4 +-
drivers/mmc/host/of_mmc_spi.c | 149 +++++++++++++++++++++++++++++++++++++++++
include/linux/spi/mmc_spi.h | 15 ++++-
4 files changed, 169 insertions(+), 2 deletions(-)
create mode 100644 drivers/mmc/host/of_mmc_spi.c
diff --git a/drivers/mmc/host/Makefile b/drivers/mmc/host/Makefile
index c794cc5..f485328 100644
--- a/drivers/mmc/host/Makefile
+++ b/drivers/mmc/host/Makefile
@@ -19,6 +19,9 @@ obj-$(CONFIG_MMC_AT91) += at91_mci.o
obj-$(CONFIG_MMC_ATMELMCI) += atmel-mci.o
obj-$(CONFIG_MMC_TIFM_SD) += tifm_sd.o
obj-$(CONFIG_MMC_SPI) += mmc_spi.o
+ifeq ($(CONFIG_OF),y)
+obj-$(CONFIG_MMC_SPI) += of_mmc_spi.o
+endif
obj-$(CONFIG_MMC_S3C) += s3cmci.o
obj-$(CONFIG_MMC_SDRICOH_CS) += sdricoh_cs.o
obj-$(CONFIG_MMC_TMIO) += tmio_mmc.o
diff --git a/drivers/mmc/host/mmc_spi.c b/drivers/mmc/host/mmc_spi.c
index ad00e16..87e211d 100644
--- a/drivers/mmc/host/mmc_spi.c
+++ b/drivers/mmc/host/mmc_spi.c
@@ -1285,7 +1285,7 @@ static int mmc_spi_probe(struct spi_device *spi)
/* Platform data is used to hook up things like card sensing
* and power switching gpios.
*/
- host->pdata = spi->dev.platform_data;
+ host->pdata = mmc_spi_get_pdata(spi);
if (host->pdata)
mmc->ocr_avail = host->pdata->ocr_mask;
if (!mmc->ocr_avail) {
@@ -1368,6 +1368,7 @@ fail_glue_init:
fail_nobuf1:
mmc_free_host(mmc);
+ mmc_spi_put_pdata(spi);
dev_set_drvdata(&spi->dev, NULL);
nomem:
@@ -1402,6 +1403,7 @@ static int __devexit mmc_spi_remove(struct spi_device *spi)
spi->max_speed_hz = mmc->f_max;
mmc_free_host(mmc);
+ mmc_spi_put_pdata(spi);
dev_set_drvdata(&spi->dev, NULL);
}
return 0;
diff --git a/drivers/mmc/host/of_mmc_spi.c b/drivers/mmc/host/of_mmc_spi.c
new file mode 100644
index 0000000..fb2921f
--- /dev/null
+++ b/drivers/mmc/host/of_mmc_spi.c
@@ -0,0 +1,149 @@
+/*
+ * OpenFirmware bindings for the MMC-over-SPI driver
+ *
+ * Copyright (c) MontaVista Software, Inc. 2008.
+ *
+ * Author: Anton Vorontsov <[email protected]>
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms of the GNU General Public License as published by the
+ * Free Software Foundation; either version 2 of the License, or (at your
+ * option) any later version.
+ */
+
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/device.h>
+#include <linux/gpio.h>
+#include <linux/of.h>
+#include <linux/of_gpio.h>
+#include <linux/spi/spi.h>
+#include <linux/spi/mmc_spi.h>
+#include <linux/mmc/core.h>
+#include <linux/mmc/host.h>
+
+enum {
+ CD_GPIO = 0,
+ WP_GPIO,
+ NUM_GPIOS,
+};
+
+struct of_mmc_spi {
+ int gpios[NUM_GPIOS];
+ bool alow_gpios[NUM_GPIOS];
+ struct mmc_spi_platform_data pdata;
+};
+
+static struct of_mmc_spi *to_of_mmc_spi(struct device *dev)
+{
+ return container_of(dev->platform_data, struct of_mmc_spi, pdata);
+}
+
+static int of_mmc_spi_read_gpio(struct device *dev, int gpio_num)
+{
+ struct of_mmc_spi *oms = to_of_mmc_spi(dev);
+ bool active_low = oms->alow_gpios[gpio_num];
+ bool value = gpio_get_value(oms->gpios[gpio_num]);
+
+ return active_low ^ value;
+}
+
+static int of_mmc_spi_get_cd(struct device *dev)
+{
+ return of_mmc_spi_read_gpio(dev, CD_GPIO);
+}
+
+static int of_mmc_spi_get_ro(struct device *dev)
+{
+ return of_mmc_spi_read_gpio(dev, WP_GPIO);
+}
+
+struct mmc_spi_platform_data *mmc_spi_get_pdata(struct spi_device *spi)
+{
+ struct device *dev = &spi->dev;
+ struct device_node *np = dev_archdata_get_node(&dev->archdata);
+ struct of_mmc_spi *oms;
+ const u32 *voltage_ranges;
+ int num_ranges;
+ int i;
+ int ret = -EINVAL;
+
+ if (dev->platform_data || !np)
+ return dev->platform_data;
+
+ oms = kzalloc(sizeof(*oms), GFP_KERNEL);
+ if (!oms)
+ return NULL;
+
+ voltage_ranges = of_get_property(np, "voltage-ranges", &num_ranges);
+ num_ranges = num_ranges / sizeof(*voltage_ranges) / 2;
+ if (!voltage_ranges || !num_ranges) {
+ dev_err(dev, "OF: voltage-ranges unspecified\n");
+ goto err_ocr;
+ }
+
+ for (i = 0; i < num_ranges; i++) {
+ const int j = i * 2;
+ u32 mask;
+
+ mask = mmc_vddrange_to_ocrmask(voltage_ranges[j],
+ voltage_ranges[j + 1]);
+ if (!mask) {
+ ret = -EINVAL;
+ dev_err(dev, "OF: voltage-range #%d is invalid\n", i);
+ goto err_ocr;
+ }
+ oms->pdata.ocr_mask |= mask;
+ }
+
+ for (i = 0; i < ARRAY_SIZE(oms->gpios); i++) {
+ enum of_gpio_flags gpio_flags;
+
+ oms->gpios[i] = of_get_gpio_flags(np, i, &gpio_flags);
+ if (!gpio_is_valid(oms->gpios[i]))
+ continue;
+
+ ret = gpio_request(oms->gpios[i], dev->bus_id);
+ if (ret < 0) {
+ oms->gpios[i] = -EINVAL;
+ continue;
+ }
+
+ if (gpio_flags & OF_GPIO_ACTIVE_LOW)
+ oms->alow_gpios[i] = true;
+ }
+
+ if (gpio_is_valid(oms->gpios[CD_GPIO]))
+ oms->pdata.get_cd = of_mmc_spi_get_cd;
+ if (gpio_is_valid(oms->gpios[WP_GPIO]))
+ oms->pdata.get_ro = of_mmc_spi_get_ro;
+
+ /* We don't support interrupts yet, let's poll. */
+ oms->pdata.caps |= MMC_CAP_NEEDS_POLL;
+
+ dev->platform_data = &oms->pdata;
+ return dev->platform_data;
+err_ocr:
+ kfree(oms);
+ return NULL;
+}
+EXPORT_SYMBOL(mmc_spi_get_pdata);
+
+void mmc_spi_put_pdata(struct spi_device *spi)
+{
+ struct device *dev = &spi->dev;
+ struct device_node *np = dev_archdata_get_node(&dev->archdata);
+ struct of_mmc_spi *oms = to_of_mmc_spi(dev);
+ int i;
+
+ if (!dev->platform_data || !np)
+ return;
+
+ for (i = 0; i < ARRAY_SIZE(oms->gpios); i++) {
+ if (gpio_is_valid(oms->gpios[i]))
+ gpio_free(oms->gpios[i]);
+ }
+ kfree(oms);
+ dev->platform_data = NULL;
+}
+EXPORT_SYMBOL(mmc_spi_put_pdata);
diff --git a/include/linux/spi/mmc_spi.h b/include/linux/spi/mmc_spi.h
index a3626ae..0f4eb16 100644
--- a/include/linux/spi/mmc_spi.h
+++ b/include/linux/spi/mmc_spi.h
@@ -1,9 +1,10 @@
#ifndef __LINUX_SPI_MMC_SPI_H
#define __LINUX_SPI_MMC_SPI_H
+#include <linux/device.h>
+#include <linux/spi/spi.h>
#include <linux/interrupt.h>
-struct device;
struct mmc_host;
/* Put this in platform_data of a device being used to manage an MMC/SD
@@ -41,4 +42,16 @@ struct mmc_spi_platform_data {
void (*setpower)(struct device *, unsigned int maskval);
};
+#ifdef CONFIG_OF
+extern struct mmc_spi_platform_data *mmc_spi_get_pdata(struct spi_device *spi);
+extern void mmc_spi_put_pdata(struct spi_device *spi);
+#else
+static inline struct mmc_spi_platform_data *
+mmc_spi_get_pdata(struct spi_device *spi)
+{
+ return spi->dev.platform_data;
+}
+static inline void mmc_spi_put_pdata(struct spi_device *spi) {}
+#endif /* CONFIG_OF */
+
#endif /* __LINUX_SPI_MMC_SPI_H */
--
1.5.6.5
On Tue, 30 Dec 2008 18:15:28 +0300
Anton Vorontsov <[email protected]> wrote:
> The support is implemented via platform data accessors, new module
> (of_mmc_spi) will be created automatically when the driver compiles
> on OpenFirmware platforms. Link-time dependency will load the module
> automatically.
>
> Signed-off-by: Anton Vorontsov <[email protected]>
> ---
Queued up.
>
> Hello Pierre,
>
> All the needed patches were merged into Linus' tree, so I believe
> it's time for the bindings.
>
> Note that you need to pull Linus' tree into mmc.git's next branch
> before applying this patch, otherwise it will break bisect, since
> of_mmc_spi isn't buildable without some patches that are in Linus'
> tree, but not in the current mmc.git next.
>
mmc.git#next gets rebased constantly to the current linus HEAD, so this
isn't a problem. And since this doesn't really mess with the old SPI
driver, I'm pushing this for .29.
Rgds
--
-- Pierre Ossman
Linux kernel, MMC maintainer http://www.kernel.org
rdesktop, core developer http://www.rdesktop.org
WARNING: This correspondence is being monitored by the
Swedish government. Make sure your server uses encryption
for SMTP traffic and consider using PGP for end-to-end
encryption.