struct uart_port::iobase is unsigned long, so use %lx as printk
format specifier.
Signed-off-by: Lennert Buytenhek <[email protected]>
diff --git a/drivers/serial/8250.c b/drivers/serial/8250.c
index b1ae774..737b4c9 100644
--- a/drivers/serial/8250.c
+++ b/drivers/serial/8250.c
@@ -1089,7 +1089,7 @@ static void autoconfig(struct uart_8250_port *up, unsigned int probeflags)
if (!up->port.iobase && !up->port.mapbase && !up->port.membase)
return;
- DEBUG_AUTOCONF("ttyS%d: autoconf (0x%04x, 0x%p): ",
+ DEBUG_AUTOCONF("ttyS%d: autoconf (0x%04lx, 0x%p): ",
serial_index(&up->port), up->port.iobase, up->port.membase);
/*
diff --git a/drivers/serial/8250_pci.c b/drivers/serial/8250_pci.c
index e7108e7..34b0b2b 100644
--- a/drivers/serial/8250_pci.c
+++ b/drivers/serial/8250_pci.c
@@ -2340,7 +2340,7 @@ pciserial_init_ports(struct pci_dev *dev, const struct pciserial_board *board)
break;
#ifdef SERIAL_DEBUG_PCI
- printk(KERN_DEBUG "Setup PCI port: port %x, irq %d, type %d\n",
+ printk(KERN_DEBUG "Setup PCI port: port %lx, irq %d, type %d\n",
serial_port.iobase, serial_port.irq, serial_port.iotype);
#endif
--