2010-07-27 21:47:08

by Joe Perches

[permalink] [raw]
Subject: [PATCH net-next] drivers/net/vxge/vxge-main.c: Use pr_<level> and netdev_<level>

Use pr_fmt, pr_<level> and netdev_<level> where appropriate.

Signed-off-by: Joe Perches <[email protected]>
---
drivers/net/vxge/vxge-main.c | 27 +++++++++++----------------
1 files changed, 11 insertions(+), 16 deletions(-)

diff --git a/drivers/net/vxge/vxge-main.c b/drivers/net/vxge/vxge-main.c
index 94d87e8..c7c5605 100644
--- a/drivers/net/vxge/vxge-main.c
+++ b/drivers/net/vxge/vxge-main.c
@@ -41,6 +41,8 @@
*
******************************************************************************/

+#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
+
#include <linux/if_vlan.h>
#include <linux/pci.h>
#include <linux/slab.h>
@@ -144,7 +146,7 @@ vxge_callback_link_up(struct __vxge_hw_device *hldev)

vxge_debug_entryexit(VXGE_TRACE, "%s: %s:%d",
vdev->ndev->name, __func__, __LINE__);
- printk(KERN_NOTICE "%s: Link Up\n", vdev->ndev->name);
+ netdev_notice(vdev->ndev, "Link Up\n");
vdev->stats.link_up++;

netif_carrier_on(vdev->ndev);
@@ -168,7 +170,7 @@ vxge_callback_link_down(struct __vxge_hw_device *hldev)

vxge_debug_entryexit(VXGE_TRACE,
"%s: %s:%d", vdev->ndev->name, __func__, __LINE__);
- printk(KERN_NOTICE "%s: Link Down\n", vdev->ndev->name);
+ netdev_notice(vdev->ndev, "Link Down\n");

vdev->stats.link_down++;
netif_carrier_off(vdev->ndev);
@@ -2679,7 +2681,7 @@ vxge_open(struct net_device *dev)

if (vxge_hw_device_link_state_get(vdev->devh) == VXGE_HW_LINK_UP) {
netif_carrier_on(vdev->ndev);
- printk(KERN_NOTICE "%s: Link Up\n", vdev->ndev->name);
+ netdev_notice(vdev->ndev, "Link Up\n");
vdev->stats.link_up++;
}

@@ -2817,7 +2819,7 @@ int do_vxge_close(struct net_device *dev, int do_io)
}

netif_carrier_off(vdev->ndev);
- printk(KERN_NOTICE "%s: Link Down\n", vdev->ndev->name);
+ netdev_notice(vdev->ndev, "Link Down\n");
netif_tx_stop_all_queues(vdev->ndev);

/* Note that at this point xmit() is stopped by upper layer */
@@ -3844,9 +3846,7 @@ static pci_ers_result_t vxge_io_slot_reset(struct pci_dev *pdev)
struct vxgedev *vdev = netdev_priv(netdev);

if (pci_enable_device(pdev)) {
- printk(KERN_ERR "%s: "
- "Cannot re-enable device after reset\n",
- VXGE_DRIVER_NAME);
+ netdev_err(netdev, "Cannot re-enable device after reset\n");
return PCI_ERS_RESULT_DISCONNECT;
}

@@ -3871,9 +3871,8 @@ static void vxge_io_resume(struct pci_dev *pdev)

if (netif_running(netdev)) {
if (vxge_open(netdev)) {
- printk(KERN_ERR "%s: "
- "Can't bring device back up after reset\n",
- VXGE_DRIVER_NAME);
+ netdev_err(netdev,
+ "Can't bring device back up after reset\n");
return;
}
}
@@ -4430,13 +4429,9 @@ static int __init
vxge_starter(void)
{
int ret = 0;
- char version[32];
- snprintf(version, 32, "%s", DRV_VERSION);

- printk(KERN_INFO "%s: Copyright(c) 2002-2010 Exar Corp.\n",
- VXGE_DRIVER_NAME);
- printk(KERN_INFO "%s: Driver version: %s\n",
- VXGE_DRIVER_NAME, version);
+ pr_info("Copyright(c) 2002-2010 Exar Corp.\n");
+ pr_info("Driver version: %s\n", DRV_VERSION);

verify_bandwidth();



2010-07-28 03:21:58

by Jon Mason

[permalink] [raw]
Subject: Re: [PATCH net-next] drivers/net/vxge/vxge-main.c: Use pr_<level> and netdev_<level>

On Tue, Jul 27, 2010 at 02:47:03PM -0700, Joe Perches wrote:
> Use pr_fmt, pr_<level> and netdev_<level> where appropriate.
>
> Signed-off-by: Joe Perches <[email protected]>

Acked-by: Jon Mason <[email protected]>

> ---
> drivers/net/vxge/vxge-main.c | 27 +++++++++++----------------
> 1 files changed, 11 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/net/vxge/vxge-main.c b/drivers/net/vxge/vxge-main.c
> index 94d87e8..c7c5605 100644
> --- a/drivers/net/vxge/vxge-main.c
> +++ b/drivers/net/vxge/vxge-main.c
> @@ -41,6 +41,8 @@
> *
> ******************************************************************************/
>
> +#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
> +
> #include <linux/if_vlan.h>
> #include <linux/pci.h>
> #include <linux/slab.h>
> @@ -144,7 +146,7 @@ vxge_callback_link_up(struct __vxge_hw_device *hldev)
>
> vxge_debug_entryexit(VXGE_TRACE, "%s: %s:%d",
> vdev->ndev->name, __func__, __LINE__);
> - printk(KERN_NOTICE "%s: Link Up\n", vdev->ndev->name);
> + netdev_notice(vdev->ndev, "Link Up\n");
> vdev->stats.link_up++;
>
> netif_carrier_on(vdev->ndev);
> @@ -168,7 +170,7 @@ vxge_callback_link_down(struct __vxge_hw_device *hldev)
>
> vxge_debug_entryexit(VXGE_TRACE,
> "%s: %s:%d", vdev->ndev->name, __func__, __LINE__);
> - printk(KERN_NOTICE "%s: Link Down\n", vdev->ndev->name);
> + netdev_notice(vdev->ndev, "Link Down\n");
>
> vdev->stats.link_down++;
> netif_carrier_off(vdev->ndev);
> @@ -2679,7 +2681,7 @@ vxge_open(struct net_device *dev)
>
> if (vxge_hw_device_link_state_get(vdev->devh) == VXGE_HW_LINK_UP) {
> netif_carrier_on(vdev->ndev);
> - printk(KERN_NOTICE "%s: Link Up\n", vdev->ndev->name);
> + netdev_notice(vdev->ndev, "Link Up\n");
> vdev->stats.link_up++;
> }
>
> @@ -2817,7 +2819,7 @@ int do_vxge_close(struct net_device *dev, int do_io)
> }
>
> netif_carrier_off(vdev->ndev);
> - printk(KERN_NOTICE "%s: Link Down\n", vdev->ndev->name);
> + netdev_notice(vdev->ndev, "Link Down\n");
> netif_tx_stop_all_queues(vdev->ndev);
>
> /* Note that at this point xmit() is stopped by upper layer */
> @@ -3844,9 +3846,7 @@ static pci_ers_result_t vxge_io_slot_reset(struct pci_dev *pdev)
> struct vxgedev *vdev = netdev_priv(netdev);
>
> if (pci_enable_device(pdev)) {
> - printk(KERN_ERR "%s: "
> - "Cannot re-enable device after reset\n",
> - VXGE_DRIVER_NAME);
> + netdev_err(netdev, "Cannot re-enable device after reset\n");
> return PCI_ERS_RESULT_DISCONNECT;
> }
>
> @@ -3871,9 +3871,8 @@ static void vxge_io_resume(struct pci_dev *pdev)
>
> if (netif_running(netdev)) {
> if (vxge_open(netdev)) {
> - printk(KERN_ERR "%s: "
> - "Can't bring device back up after reset\n",
> - VXGE_DRIVER_NAME);
> + netdev_err(netdev,
> + "Can't bring device back up after reset\n");
> return;
> }
> }
> @@ -4430,13 +4429,9 @@ static int __init
> vxge_starter(void)
> {
> int ret = 0;
> - char version[32];
> - snprintf(version, 32, "%s", DRV_VERSION);
>
> - printk(KERN_INFO "%s: Copyright(c) 2002-2010 Exar Corp.\n",
> - VXGE_DRIVER_NAME);
> - printk(KERN_INFO "%s: Driver version: %s\n",
> - VXGE_DRIVER_NAME, version);
> + pr_info("Copyright(c) 2002-2010 Exar Corp.\n");
> + pr_info("Driver version: %s\n", DRV_VERSION);
>
> verify_bandwidth();
>
>
>

2010-07-31 06:28:08

by David Miller

[permalink] [raw]
Subject: Re: [PATCH net-next] drivers/net/vxge/vxge-main.c: Use pr_<level> and netdev_<level>

From: Jon Mason <[email protected]>
Date: Tue, 27 Jul 2010 22:21:18 -0500

> On Tue, Jul 27, 2010 at 02:47:03PM -0700, Joe Perches wrote:
>> Use pr_fmt, pr_<level> and netdev_<level> where appropriate.
>>
>> Signed-off-by: Joe Perches <[email protected]>
>
> Acked-by: Jon Mason <[email protected]>

Applied.