Move enable_IR_x2apic() inside the default_setup_apic_routing()
And for smp platforms, move the default_setup_apic_routing() after
smp_sanity_check(). This cleans up the code that tries to avoid multiple
calls to default_setup_apic_routing() when smp_sanity_check() fails (which
goes through the APIC_init_uniprocessor() path)
Signed-off-by: Suresh Siddha <[email protected]>
---
arch/x86/kernel/apic/apic.c | 3 ---
arch/x86/kernel/apic/probe_64.c | 3 +++
arch/x86/kernel/smpboot.c | 4 ++--
3 files changed, 5 insertions(+), 5 deletions(-)
Index: tip/arch/x86/kernel/apic/apic.c
===================================================================
--- tip.orig/arch/x86/kernel/apic/apic.c
+++ tip/arch/x86/kernel/apic/apic.c
@@ -1665,10 +1665,7 @@ int __init APIC_init_uniprocessor(void)
}
#endif
-#ifndef CONFIG_SMP
- enable_IR_x2apic();
default_setup_apic_routing();
-#endif
verify_local_APIC();
connect_bsp_APIC();
Index: tip/arch/x86/kernel/apic/probe_64.c
===================================================================
--- tip.orig/arch/x86/kernel/apic/probe_64.c
+++ tip/arch/x86/kernel/apic/probe_64.c
@@ -54,6 +54,9 @@ static int apicid_phys_pkg_id(int initia
*/
void __init default_setup_apic_routing(void)
{
+
+ enable_IR_x2apic();
+
#ifdef CONFIG_X86_X2APIC
if (x2apic_mode
#ifdef CONFIG_X86_UV
Index: tip/arch/x86/kernel/smpboot.c
===================================================================
--- tip.orig/arch/x86/kernel/smpboot.c
+++ tip/arch/x86/kernel/smpboot.c
@@ -1107,8 +1107,6 @@ void __init native_smp_prepare_cpus(unsi
}
set_cpu_sibling_map(0);
- enable_IR_x2apic();
- default_setup_apic_routing();
if (smp_sanity_check(max_cpus) < 0) {
printk(KERN_INFO "SMP disabled\n");
@@ -1116,6 +1114,8 @@ void __init native_smp_prepare_cpus(unsi
goto out;
}
+ default_setup_apic_routing();
+
preempt_disable();
if (read_apic_id() != boot_cpu_physical_apicid) {
panic("Boot APIC ID in local APIC unexpected (%d vs %d)",