Hi Linus,
On Thu, Jan 26, 2012 at 10:17:15PM +0100, Linus Walleij wrote:
> From: Chris Blair <[email protected]>
>
> Adds support for boards which have an STMPE GPIO device without the
> interrupt pin connected. This means that no interrupt can be received
> but the GPIO pins can still be driven and read.
>
> Cc: Grant Likely <[email protected]>
> Acked-by: Viresh Kumar <[email protected]>
> Tested-by: Michel Jaouen <[email protected]>
> Signed-off-by: Chris Blair <[email protected]>
> ---
> ChangeLog v1->v2:
> - Removes the use of the new no_irq platform data member and
> instead uses the value obtained for the cell irq to know if irqs
> are supported or not. If irqs are not supported, the device
> will not have been given an irq resource and the irq value
> will be invalid.
>
> This depends on the previous patch to the MFD
> code so should better be merged into the MFD tree with the
> previous patch.
Ok, I'm taking this one. It would be nice to get Grant's ACK as well.
Linus, you did not SOB this one. Did you simply forget ?
Cheers,
Samuel.
--
Intel Open Source Technology Centre
http://oss.intel.com/