Use the dev_printk() routines to output the kernel messages in the
attach routine.
The main 'attach' message had a level of KERN_ERR, I believe it should
have been KERN_INFO. Also, move that message to the end of the attach
so it only gets displayed if the attach is successful.
Signed-off-by: H Hartley Sweeten <[email protected]>
Cc: Ian Abbott <[email protected]>
Cc: Frank Mori Hess <[email protected]>
Cc: Greg Kroah-hartman <[email protected]>
---
drivers/staging/comedi/drivers/ni_daq_700.c | 10 ++++++----
1 file changed, 6 insertions(+), 4 deletions(-)
diff --git a/drivers/staging/comedi/drivers/ni_daq_700.c b/drivers/staging/comedi/drivers/ni_daq_700.c
index 94cb346..50fad12 100644
--- a/drivers/staging/comedi/drivers/ni_daq_700.c
+++ b/drivers/staging/comedi/drivers/ni_daq_700.c
@@ -113,11 +113,8 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it)
return -EIO;
iobase = link->resource[0]->start;
- printk(KERN_ERR "comedi%d: ni_daq_700: %s, io 0x%lx\n", dev->minor,
- thisboard->name, iobase);
-
if (iobase == 0) {
- printk(KERN_ERR "io base address is zero!\n");
+ dev_err(dev->class_dev, "io base address is zero!\n");
return -EINVAL;
}
@@ -142,6 +139,11 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it)
s->state = 0;
s->io_bits = 0x00ff;
+ dev_info(dev->class_dev, "%s: %s, io 0x%lx\n",
+ dev->driver->driver_name,
+ dev->board_name,
+ dev->iobase);
+
return 0;
};
--
1.7.11