The "local configuration register" stuff is not required. The
io base/range are only queried for use in a kernel message
that it just added noise. Similar with the io range for the
actual io base used by the driver.
Remove both printk's and all the unnecessary code.
Signed-off-by: H Hartley Sweeten <[email protected]>
Cc: Ian Abbott <[email protected]>
Cc: Frank Mori Hess <[email protected]>
Cc: Greg Kroah-Hartman <[email protected]>
---
drivers/staging/comedi/drivers/adl_pci6208.c | 19 +------------------
1 file changed, 1 insertion(+), 18 deletions(-)
diff --git a/drivers/staging/comedi/drivers/adl_pci6208.c b/drivers/staging/comedi/drivers/adl_pci6208.c
index b6a8439..a96fac4 100644
--- a/drivers/staging/comedi/drivers/adl_pci6208.c
+++ b/drivers/staging/comedi/drivers/adl_pci6208.c
@@ -229,7 +229,7 @@ static int
pci6208_pci_setup(struct pci_dev *pci_dev, unsigned long *io_base_ptr,
int dev_minor)
{
- unsigned long io_base, io_range, lcr_io_base, lcr_io_range;
+ unsigned long io_base;
/* Enable PCI device and request regions */
if (comedi_pci_enable(pci_dev, "adl_pci6208") < 0) {
@@ -238,28 +238,11 @@ pci6208_pci_setup(struct pci_dev *pci_dev, unsigned long *io_base_ptr,
dev_minor);
return -EIO;
}
- /* Read local configuration register
- * base address [PCI_BASE_ADDRESS #1].
- */
- lcr_io_base = pci_resource_start(pci_dev, 1);
- lcr_io_range = pci_resource_len(pci_dev, 1);
-
- printk(KERN_INFO "comedi%d: local config registers at address"
- " 0x%4lx [0x%4lx]\n",
- dev_minor, lcr_io_base, lcr_io_range);
/* Read PCI6208 register base address [PCI_BASE_ADDRESS #2]. */
io_base = pci_resource_start(pci_dev, 2);
- io_range = pci_resource_end(pci_dev, 2) - io_base + 1;
-
- printk("comedi%d: 6208 registers at address 0x%4lx [0x%4lx]\n",
- dev_minor, io_base, io_range);
*io_base_ptr = io_base;
- /* devpriv->io_range = io_range; */
- /* devpriv->is_valid=0; */
- /* devpriv->lcr_io_base=lcr_io_base; */
- /* devpriv->lcr_io_range=lcr_io_range; */
return 0;
}
--
1.7.11