From: Steve Twiss <[email protected]>
The following describes the driver DA9210 from Dialog Semiconductor Ltd.
This is a request for comment relating to the Dialog DA9210 driver.
The patches have been made relative to the following kernel version:
linux-next next-20130620
This driver is for the Dialog DA9210 Multi-phase 12A DC-DC Buck
Converter controlled only from an I2C bus. It consists of a I2C device
driver which controls a synchronous 12 Amp step down converter. In this
case, the regulator component contains all parts of the driver in a
single file.
It would be appreciated if you could add any comments you may have about
the driver.
Thank you,
Steve Twiss, Dialog Semiconductor Ltd.
S Twiss (1):
COMMIT 1: DA9210 driver files
drivers/regulator/Kconfig | 7 +
drivers/regulator/Makefile | 1 +
drivers/regulator/da9210-regulator.c | 334 ++++++++++++++++++++++++++++
include/linux/regulator/da9210-regulator.h | 286 ++++++++++++++++++++++++
4 files changed, 628 insertions(+), 0 deletions(-)
create mode 100644 drivers/regulator/da9210-regulator.c
create mode 100644 include/linux/regulator/da9210-regulator.h
--
end-of-patch for RFC V1
On Thu, Jun 20, 2013 at 02:42:04PM +0100, Steve Twiss wrote:
> From: Steve Twiss <[email protected]>
>
> The following describes the driver DA9210 from Dialog Semiconductor Ltd.
>
> This is a request for comment relating to the Dialog DA9210 driver.
> The patches have been made relative to the following kernel version:
Don't send cover letters for single patches, if there's something that
needs saying that can't go in the commit message put it after the --- in
the e-mail.