2016-11-21 04:58:45

by Jaehoon Chung

[permalink] [raw]
Subject: [PATCHv2] arm64: dts: exynos: add the mshc_2 node for supporting T-Flash

Add the mshc_2 node for supporting T-flash.

And it needs to add the "mshc*" aliases. Because dwmmc driver should be
assigned to "ctrl_id" after parsing to "mshc".
If there is no aliases for mshc, then it might be set to the wrong
capabilities.

Signed-off-by: Jaehoon Chung <[email protected]>
---
Changelog on V2:
- Changed from 0 to GPIO_ACTIVE_HIGH

arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 19 +++++++++++++++++++
1 file changed, 19 insertions(+)

diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
index ce41781..88cb6c1 100644
--- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
+++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
@@ -45,6 +45,8 @@
spi2 = &spi_2;
spi3 = &spi_3;
spi4 = &spi_4;
+ mshc0 = &mshc_0;
+ mshc2 = &mshc_2;
};

chosen {
@@ -715,6 +717,23 @@
assigned-clock-rates = <800000000>;
};

+&mshc_2 {
+ status = "okay";
+ num-slots = <1>;
+ cap-sd-highspeed;
+ disable-wp;
+ cd-gpios = <&gpa2 4 GPIO_ACTIVE_HIGH>;
+ cd-inverted;
+ card-detect-delay = <200>;
+ samsung,dw-mshc-ciu-div = <3>;
+ samsung,dw-mshc-sdr-timing = <0 4>;
+ samsung,dw-mshc-ddr-timing = <0 2>;
+ fifo-depth = <0x80>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_bus1 &sd2_bus4>;
+ bus-width = <4>;
+};
+
&pinctrl_alive {
pinctrl-names = "default";
pinctrl-0 = <&initial_alive>;
--
2.10.1


2016-11-21 17:21:55

by Krzysztof Kozlowski

[permalink] [raw]
Subject: Re: [PATCHv2] arm64: dts: exynos: add the mshc_2 node for supporting T-Flash

On Mon, Nov 21, 2016 at 01:58:39PM +0900, Jaehoon Chung wrote:
> Add the mshc_2 node for supporting T-flash.
>
> And it needs to add the "mshc*" aliases. Because dwmmc driver should be
> assigned to "ctrl_id" after parsing to "mshc".
> If there is no aliases for mshc, then it might be set to the wrong
> capabilities.
>
> Signed-off-by: Jaehoon Chung <[email protected]>
> ---
> Changelog on V2:
> - Changed from 0 to GPIO_ACTIVE_HIGH


Thanks, applied.

Best regards,
Krzysztof