The timeout variable could be zero even if the bits has expected result.
The checking expected bits again would be better instead whether
the timeout value is zero or not.
Signed-off-by: Daeseok Youn <[email protected]>
---
drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c b/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c
index 94bc793..f2e5749 100644
--- a/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c
+++ b/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c
@@ -220,11 +220,11 @@ static int write_target_freq_to_hw(struct atomisp_device *isp,
timeout--;
}
- if (timeout != 0)
+ if (!(isp_sspm1 & ISP_FREQ_VALID_MASK))
break;
}
- if (timeout == 0) {
+ if (isp_sspm1 & ISP_FREQ_VALID_MASK) {
dev_err(isp->dev, "DFS failed due to HW error.\n");
return -EINVAL;
}
@@ -238,7 +238,7 @@ static int write_target_freq_to_hw(struct atomisp_device *isp,
udelay(100);
timeout--;
}
- if (timeout == 0) {
+ if ((isp_sspm1 >> ISP_FREQ_STAT_OFFSET) != ratio) {
dev_err(isp->dev, "DFS target freq is rejected by HW.\n");
return -EINVAL;
}
--
1.9.1