From: Lanqing Liu <[email protected]>
On Spreadtrum's serial device, nearly all of interrupts would be cleared
by hardware except timeout interrupt. This patch removed the operation
of clearing all interrupt in irq handler, instead added an if statement
to check if the timeout interrupt is supposed to be cleared.
Wrongly clearing timeout interrupt would lead to uart data stay in rx
fifo, that means the driver cannot read them out anymore.
Signed-off-by: Lanqing Liu <[email protected]>
Signed-off-by: Chunyan Zhang <[email protected]>
---
drivers/tty/serial/sprd_serial.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/sprd_serial.c b/drivers/tty/serial/sprd_serial.c
index 90996ad..f758fe6 100644
--- a/drivers/tty/serial/sprd_serial.c
+++ b/drivers/tty/serial/sprd_serial.c
@@ -63,6 +63,7 @@
/* interrupt clear register */
#define SPRD_ICLR 0x0014
+#define SPRD_ICLR_TIMEOUT BIT(13)
/* line control register */
#define SPRD_LCR 0x0018
@@ -298,7 +299,8 @@ static irqreturn_t sprd_handle_irq(int irq, void *dev_id)
return IRQ_NONE;
}
- serial_out(port, SPRD_ICLR, ~0);
+ if (ims & SPRD_IMSR_TIMEOUT)
+ serial_out(port, SPRD_ICLR, SPRD_ICLR_TIMEOUT);
if (ims & (SPRD_IMSR_RX_FIFO_FULL |
SPRD_IMSR_BREAK_DETECT | SPRD_IMSR_TIMEOUT))
--
2.7.4