pblk_line_gc_list seems to had a bug since the introduction of pblk in
getting GC list for a line. In b20ba1bc7 while redesigning GC
algorithm it was not fixed correctly. The problem is that even if
valid sector count (vsc) is less that mid_thrs (threshold for GC mid
list) it would always satisfy 'vsc < high_thrs' as high_thrs >
mid_thrs always.
Fixes: a4bd217b4("lightnvm: physical block device (pblk) target")
Signed-off-by: Rakesh Pandit <[email protected]>
---
drivers/lightnvm/pblk-core.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/lightnvm/pblk-core.c b/drivers/lightnvm/pblk-core.c
index 8150164..93a58ed 100644
--- a/drivers/lightnvm/pblk-core.c
+++ b/drivers/lightnvm/pblk-core.c
@@ -295,16 +295,16 @@ struct list_head *pblk_line_gc_list(struct pblk *pblk, struct pblk_line *line)
line->gc_group = PBLK_LINEGC_FULL;
move_list = &l_mg->gc_full_list;
}
- } else if (vsc < lm->high_thrs) {
- if (line->gc_group != PBLK_LINEGC_HIGH) {
- line->gc_group = PBLK_LINEGC_HIGH;
- move_list = &l_mg->gc_high_list;
- }
} else if (vsc < lm->mid_thrs) {
if (line->gc_group != PBLK_LINEGC_MID) {
line->gc_group = PBLK_LINEGC_MID;
move_list = &l_mg->gc_mid_list;
}
+ } else if (vsc < lm->high_thrs) {
+ if (line->gc_group != PBLK_LINEGC_HIGH) {
+ line->gc_group = PBLK_LINEGC_HIGH;
+ move_list = &l_mg->gc_high_list;
+ }
} else if (vsc < line->sec_in_line) {
if (line->gc_group != PBLK_LINEGC_LOW) {
line->gc_group = PBLK_LINEGC_LOW;
--
2.9.3