The Raspberry Pi 3 uses the 8250-based auxilary UART of the BCM2837 SoC
as the primary serial console of the board, so enable it in the
multiplatform defconfig.
Signed-off-by: Tuomas Tynkkynen <[email protected]>
---
arch/arm/configs/multi_v7_defconfig | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm/configs/multi_v7_defconfig b/arch/arm/configs/multi_v7_defconfig
index da7387689b88..f77bd01c7927 100644
--- a/arch/arm/configs/multi_v7_defconfig
+++ b/arch/arm/configs/multi_v7_defconfig
@@ -312,6 +312,9 @@ CONFIG_INPUT_ADXL34X=m
CONFIG_SERIO_AMBAKMI=y
CONFIG_SERIAL_8250=y
CONFIG_SERIAL_8250_CONSOLE=y
+CONFIG_SERIAL_8250_EXTENDED=y
+CONFIG_SERIAL_8250_SHARE_IRQ=y
+CONFIG_SERIAL_8250_BCM2835AUX=y
CONFIG_SERIAL_8250_DW=y
CONFIG_SERIAL_8250_EM=y
CONFIG_SERIAL_8250_MT6577=y
--
2.16.1
Tuomas Tynkkynen <[email protected]> writes:
> The Raspberry Pi 3 uses the 8250-based auxilary UART of the BCM2837 SoC
> as the primary serial console of the board, so enable it in the
> multiplatform defconfig.
>
> Signed-off-by: Tuomas Tynkkynen <[email protected]>
Reviewed-by: Eric Anholt <[email protected]>
I'm planning on putting this in -next once rc1 shows up, unless people
really want it in -fixes.
Eric Anholt <[email protected]> writes:
> [ Unknown signature status ]
> Tuomas Tynkkynen <[email protected]> writes:
>
>> The Raspberry Pi 3 uses the 8250-based auxilary UART of the BCM2837 SoC
>> as the primary serial console of the board, so enable it in the
>> multiplatform defconfig.
>>
>> Signed-off-by: Tuomas Tynkkynen <[email protected]>
>
> Reviewed-by: Eric Anholt <[email protected]>
>
> I'm planning on putting this in -next once rc1 shows up, unless people
> really want it in -fixes.
Merged to bcm2835-defconfig-next. Thanks!