From: Manfred Schlaegl <[email protected]>
We increase the default limit for buffer memory allocation by a factor of
10 to 640K to prevent data loss when using fast serial interfaces.
For example when using RS485 without flow-control at speeds of 1Mbit/s
an upwards we've run into problems such as applications being too slow
to read out this buffer (on embedded devices based on imx53 or imx6).
If you want to write transmitted data to a slow SD card and thus have
realtime requirements, this limit can become a problem.
That shouldn't be the case and 640K buffers fix such problems for us.
This value is a maximum limit for allocation only. It has no effect
on systems that currently run fine. When transmission is slow enough
applications and hardware can keep up and increasing this limit
doesn't change anything.
It only _allows_ to allocate more than 2*64K in cases we currently fail to
allocate memory despite having some.
Signed-off-by: Manfred Schlaegl <[email protected]>
Signed-off-by: Martin Kepplinger <[email protected]>
---
revision history
----------------
v2: more verbose commit message answering Greg's questions
v1: initial post
drivers/tty/tty_buffer.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/tty/tty_buffer.c b/drivers/tty/tty_buffer.c
index 77070c2d1240..ec145a59f199 100644
--- a/drivers/tty/tty_buffer.c
+++ b/drivers/tty/tty_buffer.c
@@ -26,7 +26,7 @@
* Byte threshold to limit memory consumption for flip buffers.
* The actual memory limit is > 2x this amount.
*/
-#define TTYB_DEFAULT_MEM_LIMIT 65536
+#define TTYB_DEFAULT_MEM_LIMIT (640 * 1024UL)
/*
* We default to dicing tty buffer allocations to this many characters
--
2.20.1