This patch provides support for clocks needed for Dynamic Memory Controller
in Exynos5422 SoC. It adds CDREX base register addresses, new DIV, MUX and
GATE entries.
Acked-by: Chanwoo Choi <[email protected]>
Acked-by: Krzysztof Kozlowski <[email protected]>
Signed-off-by: Lukasz Luba <[email protected]>
---
drivers/clk/samsung/clk-exynos5420.c | 61 +++++++++++++++++++++++++---
1 file changed, 55 insertions(+), 6 deletions(-)
diff --git a/drivers/clk/samsung/clk-exynos5420.c b/drivers/clk/samsung/clk-exynos5420.c
index 34cce3c5898f..514e16310227 100644
--- a/drivers/clk/samsung/clk-exynos5420.c
+++ b/drivers/clk/samsung/clk-exynos5420.c
@@ -134,6 +134,8 @@
#define SRC_CDREX 0x20200
#define DIV_CDREX0 0x20500
#define DIV_CDREX1 0x20504
+#define GATE_BUS_CDREX0 0x20700
+#define GATE_BUS_CDREX1 0x20704
#define KPLL_LOCK 0x28000
#define KPLL_CON0 0x28100
#define SRC_KFC 0x28200
@@ -248,6 +250,8 @@ static const unsigned long exynos5x_clk_regs[] __initconst = {
DIV_CDREX1,
SRC_KFC,
DIV_KFC0,
+ GATE_BUS_CDREX0,
+ GATE_BUS_CDREX1,
};
static const unsigned long exynos5800_clk_regs[] __initconst = {
@@ -425,6 +429,9 @@ PNAME(mout_group13_5800_p) = { "dout_osc_div", "mout_sw_aclkfl1_550_cam" };
PNAME(mout_group14_5800_p) = { "dout_aclk550_cam", "dout_sclk_sw" };
PNAME(mout_group15_5800_p) = { "dout_osc_div", "mout_sw_aclk550_cam" };
PNAME(mout_group16_5800_p) = { "dout_osc_div", "mout_mau_epll_clk" };
+PNAME(mout_mx_mspll_ccore_phy_p) = { "sclk_bpll", "mout_sclk_dpll",
+ "mout_sclk_mpll", "ff_dout_spll2",
+ "mout_sclk_spll", "mout_sclk_epll"};
/* fixed rate clocks generated outside the soc */
static struct samsung_fixed_rate_clock
@@ -450,7 +457,7 @@ static const struct samsung_fixed_factor_clock
static const struct samsung_fixed_factor_clock
exynos5800_fixed_factor_clks[] __initconst = {
FFACTOR(0, "ff_dout_epll2", "mout_sclk_epll", 1, 2, 0),
- FFACTOR(0, "ff_dout_spll2", "mout_sclk_spll", 1, 2, 0),
+ FFACTOR(CLK_FF_DOUT_SPLL2, "ff_dout_spll2", "mout_sclk_spll", 1, 2, 0),
};
static const struct samsung_mux_clock exynos5800_mux_clks[] __initconst = {
@@ -472,11 +479,14 @@ static const struct samsung_mux_clock exynos5800_mux_clks[] __initconst = {
MUX(0, "mout_aclk300_disp1", mout_group5_5800_p, SRC_TOP2, 24, 2),
MUX(0, "mout_aclk300_gscl", mout_group5_5800_p, SRC_TOP2, 28, 2),
+ MUX(CLK_MOUT_MX_MSPLL_CCORE_PHY, "mout_mx_mspll_ccore_phy",
+ mout_mx_mspll_ccore_phy_p, SRC_TOP7, 0, 3),
+
MUX(CLK_MOUT_MX_MSPLL_CCORE, "mout_mx_mspll_ccore",
- mout_mx_mspll_ccore_p, SRC_TOP7, 16, 2),
+ mout_mx_mspll_ccore_p, SRC_TOP7, 16, 3),
MUX_F(CLK_MOUT_MAU_EPLL, "mout_mau_epll_clk", mout_mau_epll_clk_5800_p,
SRC_TOP7, 20, 2, CLK_SET_RATE_PARENT, 0),
- MUX(0, "sclk_bpll", mout_bpll_p, SRC_TOP7, 24, 1),
+ MUX(CLK_SCLK_BPLL, "sclk_bpll", mout_bpll_p, SRC_TOP7, 24, 1),
MUX(0, "mout_epll2", mout_epll2_5800_p, SRC_TOP7, 28, 1),
MUX(0, "mout_aclk550_cam", mout_group3_5800_p, SRC_TOP8, 16, 3),
@@ -648,7 +658,7 @@ static const struct samsung_mux_clock exynos5x_mux_clks[] __initconst = {
MUX(0, "mout_sclk_mpll", mout_mpll_p, SRC_TOP6, 0, 1),
MUX(CLK_MOUT_VPLL, "mout_sclk_vpll", mout_vpll_p, SRC_TOP6, 4, 1),
- MUX(0, "mout_sclk_spll", mout_spll_p, SRC_TOP6, 8, 1),
+ MUX(CLK_MOUT_SCLK_SPLL, "mout_sclk_spll", mout_spll_p, SRC_TOP6, 8, 1),
MUX(0, "mout_sclk_ipll", mout_ipll_p, SRC_TOP6, 12, 1),
MUX(0, "mout_sclk_rpll", mout_rpll_p, SRC_TOP6, 16, 1),
MUX_F(CLK_MOUT_EPLL, "mout_sclk_epll", mout_epll_p, SRC_TOP6, 20, 1,
@@ -806,8 +816,21 @@ static const struct samsung_div_clock exynos5x_div_clks[] __initconst = {
"mout_aclk400_disp1", DIV_TOP2, 4, 3),
/* CDREX Block */
- DIV(CLK_DOUT_PCLK_CDREX, "dout_pclk_cdrex", "dout_aclk_cdrex1",
- DIV_CDREX0, 28, 3),
+ /*
+ * The three clocks below are controlled using the same register and
+ * bits. They are put into one because there is a need of
+ * synchronization between the BUS and DREXs (two external memory
+ * interfaces).
+ * They are put here to show this HW assumption and for clock
+ * information summary completeness.
+ */
+ DIV_F(CLK_DOUT_PCLK_CDREX, "dout_pclk_cdrex", "dout_aclk_cdrex1",
+ DIV_CDREX0, 28, 3, CLK_GET_RATE_NOCACHE, 0),
+ DIV_F(CLK_DOUT_PCLK_DREX0, "dout_pclk_drex0", "dout_cclk_drex0",
+ DIV_CDREX0, 28, 3, CLK_GET_RATE_NOCACHE, 0),
+ DIV_F(CLK_DOUT_PCLK_DREX1, "dout_pclk_drex1", "dout_cclk_drex0",
+ DIV_CDREX0, 28, 3, CLK_GET_RATE_NOCACHE, 0),
+
DIV_F(CLK_DOUT_SCLK_CDREX, "dout_sclk_cdrex", "mout_mclk_cdrex",
DIV_CDREX0, 24, 3, CLK_SET_RATE_PARENT, 0),
DIV(CLK_DOUT_ACLK_CDREX1, "dout_aclk_cdrex1", "dout_clk2x_phy0",
@@ -1170,6 +1193,32 @@ static const struct samsung_gate_clock exynos5x_gate_clks[] __initconst = {
GATE_TOP_SCLK_ISP, 12, CLK_SET_RATE_PARENT, 0),
GATE(CLK_G3D, "g3d", "mout_user_aclk_g3d", GATE_IP_G3D, 9, 0, 0),
+
+ /* CDREX */
+ GATE(CLK_CLKM_PHY0, "clkm_phy0", "dout_sclk_cdrex",
+ GATE_BUS_CDREX0, 0, 0, 0),
+ GATE(CLK_CLKM_PHY1, "clkm_phy1", "dout_sclk_cdrex",
+ GATE_BUS_CDREX0, 1, 0, 0),
+ GATE(0, "mx_mspll_ccore_phy", "mout_mx_mspll_ccore_phy",
+ SRC_MASK_TOP7, 0, CLK_IGNORE_UNUSED, 0),
+
+ GATE(CLK_ACLK_PPMU_DREX1_1, "aclk_ppmu_drex1_1", "dout_aclk_cdrex1",
+ GATE_BUS_CDREX1, 12, CLK_IGNORE_UNUSED, 0),
+ GATE(CLK_ACLK_PPMU_DREX1_0, "aclk_ppmu_drex1_0", "dout_aclk_cdrex1",
+ GATE_BUS_CDREX1, 13, CLK_IGNORE_UNUSED, 0),
+ GATE(CLK_ACLK_PPMU_DREX0_1, "aclk_ppmu_drex0_1", "dout_aclk_cdrex1",
+ GATE_BUS_CDREX1, 14, CLK_IGNORE_UNUSED, 0),
+ GATE(CLK_ACLK_PPMU_DREX0_0, "aclk_ppmu_drex0_0", "dout_aclk_cdrex1",
+ GATE_BUS_CDREX1, 15, CLK_IGNORE_UNUSED, 0),
+
+ GATE(CLK_PCLK_PPMU_DREX1_1, "pclk_ppmu_drex1_1", "dout_pclk_cdrex",
+ GATE_BUS_CDREX1, 26, CLK_IGNORE_UNUSED, 0),
+ GATE(CLK_PCLK_PPMU_DREX1_0, "pclk_ppmu_drex1_0", "dout_pclk_cdrex",
+ GATE_BUS_CDREX1, 27, CLK_IGNORE_UNUSED, 0),
+ GATE(CLK_PCLK_PPMU_DREX0_1, "pclk_ppmu_drex0_1", "dout_pclk_cdrex",
+ GATE_BUS_CDREX1, 28, CLK_IGNORE_UNUSED, 0),
+ GATE(CLK_PCLK_PPMU_DREX0_0, "pclk_ppmu_drex0_0", "dout_pclk_cdrex",
+ GATE_BUS_CDREX1, 29, CLK_IGNORE_UNUSED, 0),
};
static const struct samsung_div_clock exynos5x_disp_div_clks[] __initconst = {
--
2.17.1