The mt762x GDM block is mainly used to setup the HW internal
rx path from GMAC to RX DMA engine(PDMA) and the packet
switching engine(PSE) is responsed to do the data forward
following the GDM configuration.
This patch set have three goals :
1. Integrate GDM/PSE setup operations into single function "mtk_gdm_config"
2. Refine the timing of GDM/PSE setup, move it from mtk_hw_init
to mtk_open
3. Enable GDM GDMA_DROP_ALL mode to drop all packet during the
stop operation
MarkLee (3):
net: ethernet: mediatek: Integrate GDM/PSE setup operations
net: ethernet: mediatek: Refine the timing of GDM/PSE setup
net: ethernet: mediatek: Enable GDM GDMA_DROP_ALL mode
drivers/net/ethernet/mediatek/mtk_eth_soc.c | 44 ++++++++++++++-------
drivers/net/ethernet/mediatek/mtk_eth_soc.h | 2 +
2 files changed, 31 insertions(+), 15 deletions(-)
--
2.17.1
Enable GDM GDMA_DROP_ALL mode to drop all packet during the
stop operation. This is recommended by the mt762x HW design
to drop all packet from GMAC before stopping PDMA.
Signed-off-by: MarkLee <[email protected]>
--
v1->v2:
* no change
---
drivers/net/ethernet/mediatek/mtk_eth_soc.c | 2 ++
drivers/net/ethernet/mediatek/mtk_eth_soc.h | 1 +
2 files changed, 3 insertions(+)
diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index b147ab0e44ce..5fe1ab0c16cc 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -2279,6 +2279,8 @@ static int mtk_stop(struct net_device *dev)
if (!refcount_dec_and_test(ð->dma_refcnt))
return 0;
+ mtk_gdm_config(eth, MTK_GDMA_DROP_ALL);
+
mtk_tx_irq_disable(eth, MTK_TX_DONE_INT);
mtk_rx_irq_disable(eth, MTK_RX_DONE_INT);
napi_disable(ð->tx_napi);
diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.h b/drivers/net/ethernet/mediatek/mtk_eth_soc.h
index b16d8d9b196a..85830fe14a1b 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.h
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.h
@@ -85,6 +85,7 @@
#define MTK_GDMA_TCS_EN BIT(21)
#define MTK_GDMA_UCS_EN BIT(20)
#define MTK_GDMA_TO_PDMA 0x0
+#define MTK_GDMA_DROP_ALL 0x7777
/* Unicast Filter MAC Address Register - Low */
#define MTK_GDMA_MAC_ADRL(x) (0x508 + (x * 0x1000))
--
2.17.1
Refine the timing of GDM/PSE setup, move it from mtk_hw_init
to mtk_open. This is recommended by the mt762x HW design to
do GDM/PSE setup only after PDMA has been started.
We exclude mt7628 in mtk_gdm_config function since it is a old IP
and there is no GDM/PSE block on it.
Signed-off-by: MarkLee <[email protected]>
--
v1->v2:
* no change
---
drivers/net/ethernet/mediatek/mtk_eth_soc.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index 6e7a7fea2f52..b147ab0e44ce 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -2184,6 +2184,9 @@ static void mtk_gdm_config(struct mtk_eth *eth, u32 config)
{
int i;
+ if (MTK_HAS_CAPS(eth->soc->caps, MTK_SOC_MT7628))
+ return;
+
for (i = 0; i < MTK_MAC_COUNT; i++) {
u32 val = mtk_r32(eth, MTK_GDMA_FWD_CFG(i));
@@ -2222,6 +2225,8 @@ static int mtk_open(struct net_device *dev)
if (err)
return err;
+ mtk_gdm_config(eth, MTK_GDMA_TO_PDMA);
+
napi_enable(ð->tx_napi);
napi_enable(ð->rx_napi);
mtk_tx_irq_enable(eth, MTK_TX_DONE_INT);
@@ -2405,8 +2410,6 @@ static int mtk_hw_init(struct mtk_eth *eth)
mtk_w32(eth, MTK_RX_DONE_INT, MTK_QDMA_INT_GRP2);
mtk_w32(eth, 0x21021000, MTK_FE_INT_GRP);
- mtk_gdm_config(eth, MTK_GDMA_TO_PDMA);
-
return 0;
err_disable_pm:
--
2.17.1