A64-OLinuXino-eMMC uses 1.8V for eMMC supply. This is done via a triple
jumper, which sets VCC-PL to either 1.8V or 3.3V. This setting is different
for boards with and without eMMC.
This is not a big issue for DDR52 mode, however the eMMC will not work in
HS200/HS400, since these modes explicitly requires 1.8V.
Fixes: 94f68f3a4b2a ("arm64: dts: allwinner: a64: Add A64 OlinuXino board (with eMMC)")
Cc: [email protected] # v5.4
Signed-off-by: Stefan Mavrodiev <[email protected]>
---
Changes for v2:
- Restore the original eMMC vmmc-supply property
arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
index 96ab0227e82d..121e6cc4849b 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts
@@ -15,7 +15,7 @@
pinctrl-names = "default";
pinctrl-0 = <&mmc2_pins>;
vmmc-supply = <®_dcdc1>;
- vqmmc-supply = <®_dcdc1>;
+ vqmmc-supply = <®_eldo1>;
bus-width = <8>;
non-removable;
cap-mmc-hw-reset;
--
2.17.1
On Fri, Nov 29, 2019 at 01:39:39PM +0200, Stefan Mavrodiev wrote:
> A64-OLinuXino-eMMC uses 1.8V for eMMC supply. This is done via a triple
> jumper, which sets VCC-PL to either 1.8V or 3.3V. This setting is different
> for boards with and without eMMC.
>
> This is not a big issue for DDR52 mode, however the eMMC will not work in
> HS200/HS400, since these modes explicitly requires 1.8V.
>
> Fixes: 94f68f3a4b2a ("arm64: dts: allwinner: a64: Add A64 OlinuXino board (with eMMC)")
> Cc: [email protected] # v5.4
> Signed-off-by: Stefan Mavrodiev <[email protected]>
Applied, thanks!
Maxime