2020-05-19 21:49:01

by Ahmed S. Darwish

[permalink] [raw]
Subject: [PATCH v1 03/25] net: phy: fixed_phy: Remove unused seqcount

Commit bf7afb29d545 ("phy: improve safety of fixed-phy MII register
reading") protected the fixed PHY status with a sequence counter.

Two years later, commit d2b977939b18 ("net: phy: fixed-phy: remove
fixed_phy_update_state()") removed the sequence counter's write side
critical section -- neutralizing its read side retry loop.

Remove the unused seqcount.

Signed-off-by: Ahmed S. Darwish <[email protected]>
Reviewed-by: Sebastian Andrzej Siewior <[email protected]>
---
drivers/net/phy/fixed_phy.c | 25 ++++++++++---------------
1 file changed, 10 insertions(+), 15 deletions(-)

diff --git a/drivers/net/phy/fixed_phy.c b/drivers/net/phy/fixed_phy.c
index 4a3d34f40cb9..f55365c9d1f7 100644
--- a/drivers/net/phy/fixed_phy.c
+++ b/drivers/net/phy/fixed_phy.c
@@ -34,7 +34,6 @@ struct fixed_mdio_bus {
struct fixed_phy {
int addr;
struct phy_device *phydev;
- seqcount_t seqcount;
struct fixed_phy_status status;
bool no_carrier;
int (*link_update)(struct net_device *, struct fixed_phy_status *);
@@ -80,19 +79,17 @@ static int fixed_mdio_read(struct mii_bus *bus, int phy_addr, int reg_num)
list_for_each_entry(fp, &fmb->phys, node) {
if (fp->addr == phy_addr) {
struct fixed_phy_status state;
- int s;

- do {
- s = read_seqcount_begin(&fp->seqcount);
- fp->status.link = !fp->no_carrier;
- /* Issue callback if user registered it. */
- if (fp->link_update)
- fp->link_update(fp->phydev->attached_dev,
- &fp->status);
- /* Check the GPIO for change in status */
- fixed_phy_update(fp);
- state = fp->status;
- } while (read_seqcount_retry(&fp->seqcount, s));
+ fp->status.link = !fp->no_carrier;
+
+ /* Issue callback if user registered it. */
+ if (fp->link_update)
+ fp->link_update(fp->phydev->attached_dev,
+ &fp->status);
+
+ /* Check the GPIO for change in status */
+ fixed_phy_update(fp);
+ state = fp->status;

return swphy_read_reg(reg_num, &state);
}
@@ -150,8 +147,6 @@ static int fixed_phy_add_gpiod(unsigned int irq, int phy_addr,
if (!fp)
return -ENOMEM;

- seqcount_init(&fp->seqcount);
-
if (irq != PHY_POLL)
fmb->mii_bus->irq[phy_addr] = irq;

--
2.20.1