Now all platforms are sharing sync-r4k procdure, there is no need to let
platform to select it.
Signed-off-by: Jiaxun Yang <[email protected]>
---
arch/mips/Kconfig | 10 ++--------
1 file changed, 2 insertions(+), 8 deletions(-)
diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig
index 880680c0df31..7674f4379d39 100644
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -234,7 +234,6 @@ config BMIPS_GENERIC
select USE_OF
select CEVT_R4K
select CSRC_R4K
- select SYNC_R4K
select COMMON_CLK
select BCM6345_L1_IRQ
select BCM7038_L1_IRQ
@@ -291,7 +290,6 @@ config BCM63XX
select BOOT_RAW
select CEVT_R4K
select CSRC_R4K
- select SYNC_R4K
select DMA_NONCOHERENT
select IRQ_MIPS_CPU
select SYS_SUPPORTS_32BIT_KERNEL
@@ -726,7 +724,6 @@ config SGI_IP30
select BOOT_ELF64
select CEVT_R4K
select CSRC_R4K
- select SYNC_R4K if SMP
select ZONE_DMA32
select HAVE_PCI
select IRQ_MIPS_CPU
@@ -979,7 +976,6 @@ config NLM_XLR_BOARD
select CSRC_R4K
select IRQ_MIPS_CPU
select ZONE_DMA32 if 64BIT
- select SYNC_R4K
select SYS_HAS_EARLY_PRINTK
select SYS_SUPPORTS_ZBOOT
select SYS_SUPPORTS_ZBOOT_UART16550
@@ -1006,7 +1002,6 @@ config NLM_XLP_BOARD
select CSRC_R4K
select IRQ_MIPS_CPU
select ZONE_DMA32 if 64BIT
- select SYNC_R4K
select SYS_HAS_EARLY_PRINTK
select USE_OF
select SYS_SUPPORTS_ZBOOT
@@ -1076,6 +1071,7 @@ config CEVT_GT641XX
bool
config CEVT_R4K
+ select SYNC_R4K if SMP
bool
config CEVT_SB1250
@@ -1091,6 +1087,7 @@ config CSRC_IOASIC
bool
config CSRC_R4K
+ select SYNC_R4K if SMP
select CLOCKSOURCE_WATCHDOG if CPU_FREQ
bool
@@ -2361,7 +2358,6 @@ config MIPS_MT_SMP
depends on SYS_SUPPORTS_MULTITHREADING && !CPU_MIPSR6 && !CPU_MICROMIPS
select CPU_MIPSR2_IRQ_VI
select CPU_MIPSR2_IRQ_EI
- select SYNC_R4K
select MIPS_MT
select SMP
select SMP_UP
@@ -2465,7 +2461,6 @@ config MIPS_CMP
bool "MIPS CMP framework support (DEPRECATED)"
depends on SYS_SUPPORTS_MIPS_CMP && !CPU_MIPSR6
select SMP
- select SYNC_R4K
select SYS_SUPPORTS_SMP
select WEAK_ORDERING
default n
@@ -2483,7 +2478,6 @@ config MIPS_CPS
select MIPS_CM
select MIPS_CPS_PM if HOTPLUG_CPU
select SMP
- select SYNC_R4K if (CEVT_R4K || CSRC_R4K)
select SYS_SUPPORTS_HOTPLUG_CPU
select SYS_SUPPORTS_SCHED_SMT if CPU_MIPSR6
select SYS_SUPPORTS_SMP
--
2.28.0.rc1