From: Aashish Verma <[email protected]>
netif_set_real_num_tx_queues() & netif_set_real_num_rx_queues() should be
used to inform network stack about the real Tx & Rx queue (active) number
in both stmmac_open() and stmmac_resume(), therefore, we move the code
from stmmac_dvr_probe() to stmmac_hw_setup().
Fixes: c02b7a914551 net: stmmac: use netif_set_real_num_{rx,tx}_queues
Signed-off-by: Aashish Verma <[email protected]>
Signed-off-by: Ong Boon Leong <[email protected]>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 9302d8012a10..fea3b77892ab 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -2733,6 +2733,10 @@ static int stmmac_hw_setup(struct net_device *dev, bool init_ptp)
stmmac_enable_tbs(priv, priv->ioaddr, enable, chan);
}
+ /* Configure real RX and TX queues */
+ netif_set_real_num_rx_queues(dev, priv->plat->rx_queues_to_use);
+ netif_set_real_num_tx_queues(dev, priv->plat->tx_queues_to_use);
+
/* Start the ball rolling... */
stmmac_start_all_dma(priv);
@@ -4883,10 +4887,6 @@ int stmmac_dvr_probe(struct device *device,
stmmac_check_ether_addr(priv);
- /* Configure real RX and TX queues */
- netif_set_real_num_rx_queues(ndev, priv->plat->rx_queues_to_use);
- netif_set_real_num_tx_queues(ndev, priv->plat->tx_queues_to_use);
-
ndev->netdev_ops = &stmmac_netdev_ops;
ndev->hw_features = NETIF_F_SG | NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM |
--
2.17.0