Use phy_initialization helper instead of direct invoking.
Signed-off-by: Stanley Chu <[email protected]>
---
drivers/scsi/ufs/ufshcd-dwc.c | 11 ++++-------
1 file changed, 4 insertions(+), 7 deletions(-)
diff --git a/drivers/scsi/ufs/ufshcd-dwc.c b/drivers/scsi/ufs/ufshcd-dwc.c
index 6a901da2d15a..5bb9d3a88795 100644
--- a/drivers/scsi/ufs/ufshcd-dwc.c
+++ b/drivers/scsi/ufs/ufshcd-dwc.c
@@ -120,13 +120,10 @@ int ufshcd_dwc_link_startup_notify(struct ufs_hba *hba,
if (status == PRE_CHANGE) {
ufshcd_dwc_program_clk_div(hba, DWC_UFS_REG_HCLKDIV_DIV_125);
- if (hba->vops->phy_initialization) {
- err = hba->vops->phy_initialization(hba);
- if (err) {
- dev_err(hba->dev, "Phy setup failed (%d)\n",
- err);
- goto out;
- }
+ err = ufshcd_vops_phy_initialization(hba);
+ if (err) {
+ dev_err(hba->dev, "Phy setup failed (%d)\n", err);
+ goto out;
}
} else { /* POST_CHANGE */
err = ufshcd_dwc_link_is_up(hba);
--
2.18.0