Replace "ret" variable by "irq" variable from platform_get_irq condition
handling in stm32_init_port as suggested by Jiri in "STM32 uart cleanup and
improvement" series review.
This change will prevent port->irq to be unexpectly modified by a potential
change of "ret" value introduced by a new patch.
Suggested-by: Jiri Slaby <[email protected]>
Signed-off-by: Erwan Le Ray <[email protected]>
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 6a9a5ef5f5ba..dde6d526362d 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -981,11 +981,11 @@ static int stm32_usart_init_port(struct stm32_port *stm32port,
{
struct uart_port *port = &stm32port->port;
struct resource *res;
- int ret;
+ int ret, irq;
- ret = platform_get_irq(pdev, 0);
- if (ret <= 0)
- return ret ? : -ENODEV;
+ irq = platform_get_irq(pdev, 0);
+ if (irq <= 0)
+ return irq ? : -ENODEV;
port->iotype = UPIO_MEM;
port->flags = UPF_BOOT_AUTOCONF;
@@ -993,7 +993,7 @@ static int stm32_usart_init_port(struct stm32_port *stm32port,
port->dev = &pdev->dev;
port->fifosize = stm32port->info->cfg.fifosize;
port->has_sysrq = IS_ENABLED(CONFIG_SERIAL_STM32_CONSOLE);
- port->irq = ret;
+ port->irq = irq;
port->rs485_config = stm32_usart_config_rs485;
ret = stm32_usart_init_rs485(port, pdev);
--
2.17.1