RX is configured, but usart is not enabled in startup function.
Kernel documentation specifies that startup should enable the port for
reception.
Fix the startup by enabling usart for reception.
Fixes: 84872dc448fe ("serial: stm32: add RX and TX FIFO flush")
Signed-off-by: Erwan Le Ray <[email protected]>
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index c67029ebcac8..33a479062948 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -634,6 +634,7 @@ static int stm32_usart_startup(struct uart_port *port)
{
struct stm32_port *stm32_port = to_stm32_port(port);
struct stm32_usart_offsets *ofs = &stm32_port->info->ofs;
+ struct stm32_usart_config *cfg = &stm32_port->info->cfg;
const char *name = to_platform_device(port->dev)->name;
u32 val;
int ret;
@@ -658,7 +659,7 @@ static int stm32_usart_startup(struct uart_port *port)
}
/* RX FIFO enabling */
- val = stm32_port->cr1_irq | USART_CR1_RE;
+ val = stm32_port->cr1_irq | USART_CR1_RE | BIT(cfg->uart_enable_bit);
if (stm32_port->fifoen)
val |= USART_CR1_FIFOEN;
stm32_usart_set_bits(port, ofs->cr1, val);
--
2.17.1