The 'delay_usecs' field is going away. The replacement for it is the
'delay' field. So, we should check for 'delay.value' being non-zero.
Signed-off-by: Alexandru Ardelean <[email protected]>
---
drivers/spi/spi-bcm-qspi.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/spi/spi-bcm-qspi.c b/drivers/spi/spi-bcm-qspi.c
index 707fe3a5d8ef..a78e56f566dd 100644
--- a/drivers/spi/spi-bcm-qspi.c
+++ b/drivers/spi/spi-bcm-qspi.c
@@ -671,7 +671,7 @@ static int update_qspi_trans_byte_count(struct bcm_qspi *qspi,
if (qt->byte >= qt->trans->len) {
/* we're at the end of the spi_transfer */
/* in TX mode, need to pause for a delay or CS change */
- if (qt->trans->delay_usecs &&
+ if (qt->trans->delay.value &&
(flags & TRANS_STATUS_BREAK_DELAY))
ret |= TRANS_STATUS_BREAK_DELAY;
if (qt->trans->cs_change &&
--
2.29.2