From: Chen-Yu Tsai <[email protected]>
Enable USB3 nodes for the ROC-RK3328-CC board.
The separate power regulator is not added as it is controlled by the
same GPIO line as the existing VBUS regulators, so it is already
enabled. Also there is no port representation to tie the regulator to.
Signed-off-by: Chen-Yu Tsai <[email protected]>
---
arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts b/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts
index a05732b59f38..bdf0ca07eae9 100644
--- a/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts
@@ -363,6 +363,11 @@ &usb20_otg {
status = "okay";
};
+&usbdrd3 {
+ dr_mode = "host";
+ status = "okay";
+};
+
&usb_host0_ehci {
status = "okay";
};
--
2.31.1