The new Mikrotik 10/25G NIC supports jumbo frames. Jumbo frames are
supported for TSO as well.
This enables the support for mtu up to 9500 bytes.
Signed-off-by: Gatis Peisenieks <[email protected]>
---
drivers/net/ethernet/atheros/atl1c/atl1c_main.c | 16 ++++++++++++----
1 file changed, 12 insertions(+), 4 deletions(-)
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
index 08a0f49e03ce..dbafd8118a86 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
@@ -478,6 +478,9 @@ static void atl1c_set_rxbufsize(struct atl1c_adapter *adapter,
static netdev_features_t atl1c_fix_features(struct net_device *netdev,
netdev_features_t features)
{
+ struct atl1c_adapter *adapter = netdev_priv(netdev);
+ struct atl1c_hw *hw = &adapter->hw;
+
/*
* Since there is no support for separate rx/tx vlan accel
* enable/disable make sure tx flag is always in same state as rx.
@@ -487,8 +490,10 @@ static netdev_features_t atl1c_fix_features(struct net_device *netdev,
else
features &= ~NETIF_F_HW_VLAN_CTAG_TX;
- if (netdev->mtu > MAX_TSO_FRAME_SIZE)
- features &= ~(NETIF_F_TSO | NETIF_F_TSO6);
+ if (hw->nic_type != athr_mt) {
+ if (netdev->mtu > MAX_TSO_FRAME_SIZE)
+ features &= ~(NETIF_F_TSO | NETIF_F_TSO6);
+ }
return features;
}
@@ -515,9 +520,12 @@ static void atl1c_set_max_mtu(struct net_device *netdev)
case athr_l1d:
case athr_l1d_2:
netdev->max_mtu = MAX_JUMBO_FRAME_SIZE -
- (ETH_HLEN + ETH_FCS_LEN + VLAN_HLEN);
+ (ETH_HLEN + ETH_FCS_LEN + VLAN_HLEN);
+ break;
+ case athr_mt:
+ netdev->max_mtu = 9500;
break;
- /* The 10/100 devices don't support jumbo packets, max_mtu 1500 */
+ /* The 10/100 devices don't support jumbo packets, max_mtu 1500 */
default:
netdev->max_mtu = ETH_DATA_LEN;
break;
--
2.31.1