Use GPIOD_OUT_LOW instead of GPIOD_ASIS as the reset pin needs to be an
active low output pin.
Suggested-by: Hannu Hartikainen <[email protected]>
Signed-off-by: Antti Keränen <[email protected]>
---
The documentation of GPIO consumer interface states:
Be aware that there is no default direction for GPIOs. Therefore,
**using a GPIO without setting its direction first is illegal and will
result in undefined behavior!**
Therefore the direction of the reset GPIO pin should be set as output.
drivers/iio/imu/adis.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/iio/imu/adis.c b/drivers/iio/imu/adis.c
index 319b64b2fd88..7f13b3763732 100644
--- a/drivers/iio/imu/adis.c
+++ b/drivers/iio/imu/adis.c
@@ -415,7 +415,7 @@ int __adis_initial_startup(struct adis *adis)
int ret;
/* check if the device has rst pin low */
- gpio = devm_gpiod_get_optional(&adis->spi->dev, "reset", GPIOD_ASIS);
+ gpio = devm_gpiod_get_optional(&adis->spi->dev, "reset", GPIOD_OUT_LOW);
if (IS_ERR(gpio))
return PTR_ERR(gpio);
--
2.31.1