Add a variation of RTL8822CS with hci_ver = 0x08. This is fully similar to RTL8822CS with hci_ver = 0x0a
The controller does not always start when the system starts up, so we do a forced reset via gpio during initialization.
Changes from v2:
- align the patches for bluetooth-next
Changes from v1:
- remove Signed-off-by chbgdn <[email protected]> as not reachable
Vyacheslav Bocharov (2):
Bluetooth: btrtl: Add support for RTL8822C hci_ver 0x08
Bluetooth: hci_h5: Add power reset via gpio in h5_btrtl_open
drivers/bluetooth/btrtl.c | 7 +++++++
drivers/bluetooth/hci_h5.c | 5 +++++
2 files changed, 12 insertions(+)
--
2.30.2
Add detection of RTL8822CS controller with hci_ver = 0x08
Signed-off-by: Vyacheslav Bocharov <[email protected]>
---
drivers/bluetooth/btrtl.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/bluetooth/btrtl.c b/drivers/bluetooth/btrtl.c
index c2bdd1e6060e..38d547cc6fcd 100644
--- a/drivers/bluetooth/btrtl.c
+++ b/drivers/bluetooth/btrtl.c
@@ -156,6 +156,13 @@ static const struct id_table ic_id_table[] = {
.fw_name = "rtl_bt/rtl8822cs_fw.bin",
.cfg_name = "rtl_bt/rtl8822cs_config" },
+ /* 8822C with UART interface */
+ { IC_INFO(RTL_ROM_LMP_8822B, 0xc, 0x8, HCI_UART),
+ .config_needed = true,
+ .has_rom_version = true,
+ .fw_name = "rtl_bt/rtl8822cs_fw.bin",
+ .cfg_name = "rtl_bt/rtl8822cs_config" },
+
/* 8822C with USB interface */
{ IC_INFO(RTL_ROM_LMP_8822B, 0xc, 0xa, HCI_USB),
.config_needed = false,
--
2.30.2