In uart_set_rs485_config() the serial core already clamps the RTS delays.
It also assigns the passed serial_rs485 struct to the uart port.
So remove these tasks from the drivers rs485_config() function to avoid
redundancy.
Signed-off-by: Lino Sanfilippo <[email protected]>
---
drivers/tty/serial/omap-serial.c | 13 +++----------
1 file changed, 3 insertions(+), 10 deletions(-)
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 0862941862c8..a3afcccfbd96 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1350,18 +1350,11 @@ serial_omap_config_rs485(struct uart_port *port, struct serial_rs485 *rs485)
up->ier = 0;
serial_out(up, UART_IER, 0);
- /* Clamp the delays to [0, 100ms] */
- rs485->delay_rts_before_send = min(rs485->delay_rts_before_send, 100U);
- rs485->delay_rts_after_send = min(rs485->delay_rts_after_send, 100U);
-
- /* store new config */
- port->rs485 = *rs485;
-
if (up->rts_gpiod) {
/* enable / disable rts */
- val = (port->rs485.flags & SER_RS485_ENABLED) ?
+ val = (rs485->flags & SER_RS485_ENABLED) ?
SER_RS485_RTS_AFTER_SEND : SER_RS485_RTS_ON_SEND;
- val = (port->rs485.flags & val) ? 1 : 0;
+ val = (rs485->flags & val) ? 1 : 0;
gpiod_set_value(up->rts_gpiod, val);
}
@@ -1372,7 +1365,7 @@ serial_omap_config_rs485(struct uart_port *port, struct serial_rs485 *rs485)
/* If RS-485 is disabled, make sure the THR interrupt is fired when
* TX FIFO is below the trigger level.
*/
- if (!(port->rs485.flags & SER_RS485_ENABLED) &&
+ if (!(rs485->flags & SER_RS485_ENABLED) &&
(up->scr & OMAP_UART_SCR_TX_EMPTY)) {
up->scr &= ~OMAP_UART_SCR_TX_EMPTY;
serial_out(up, UART_OMAP_SCR, up->scr);
--
2.34.1