Make sgpio_output_set() return an error value. Don't just ignore the
return value of any regmap access but propagate it to our callers. Even
if the accesses never fail, this is a preparation patch to add single
shot mode where we need to poll a bit and thus we might get -ETIMEDOUT.
Signed-off-by: Michael Walle <[email protected]>
---
drivers/pinctrl/pinctrl-microchip-sgpio.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-microchip-sgpio.c b/drivers/pinctrl/pinctrl-microchip-sgpio.c
index f01ca94943da..3f3b8c482f3a 100644
--- a/drivers/pinctrl/pinctrl-microchip-sgpio.c
+++ b/drivers/pinctrl/pinctrl-microchip-sgpio.c
@@ -225,9 +225,9 @@ static inline void sgpio_configure_clock(struct sgpio_priv *priv, u32 clkfrq)
sgpio_clrsetbits(priv, REG_SIO_CLOCK, 0, clr, set);
}
-static void sgpio_output_set(struct sgpio_priv *priv,
- struct sgpio_port_addr *addr,
- int value)
+static int sgpio_output_set(struct sgpio_priv *priv,
+ struct sgpio_port_addr *addr,
+ int value)
{
unsigned int bit = SGPIO_SRC_BITS * addr->bit;
u32 clr, set;
@@ -246,10 +246,12 @@ static void sgpio_output_set(struct sgpio_priv *priv,
set = FIELD_PREP(SGPIO_SPARX5_BIT_SOURCE, value << bit);
break;
default:
- return;
+ return -EINVAL;
}
sgpio_clrsetbits(priv, REG_PORT_CONFIG, addr->port, clr, set);
+
+ return 0;
}
static int sgpio_output_get(struct sgpio_priv *priv,
@@ -335,7 +337,7 @@ static int sgpio_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin,
case PIN_CONFIG_OUTPUT:
if (bank->is_input)
return -EINVAL;
- sgpio_output_set(priv, &addr, arg);
+ err = sgpio_output_set(priv, &addr, arg);
break;
default:
@@ -475,9 +477,7 @@ static int microchip_sgpio_direction_output(struct gpio_chip *gc,
sgpio_pin_to_addr(priv, gpio, &addr);
- sgpio_output_set(priv, &addr, value);
-
- return 0;
+ return sgpio_output_set(priv, &addr, value);
}
static int microchip_sgpio_get_direction(struct gpio_chip *gc, unsigned int gpio)
--
2.30.2