In uart_set_rs485_config() the serial core already assigns the passed
serial_rs485 struct to the uart port.
So remove the assignment from the drivers rs485_config() function to avoid
redundancy.
Acked-by: Richard Genoud <[email protected]>
Signed-off-by: Lino Sanfilippo <[email protected]>
---
drivers/tty/serial/atmel_serial.c | 4 +---
1 file changed, 1 insertion(+), 3 deletions(-)
diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index 73d43919898d..18d3bbdcb7a2 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -299,11 +299,9 @@ static int atmel_config_rs485(struct uart_port *port,
/* Resetting serial mode to RS232 (0x0) */
mode &= ~ATMEL_US_USMODE;
- port->rs485 = *rs485conf;
-
if (rs485conf->flags & SER_RS485_ENABLED) {
dev_dbg(port->dev, "Setting UART to RS485\n");
- if (port->rs485.flags & SER_RS485_RX_DURING_TX)
+ if (rs485conf->flags & SER_RS485_RX_DURING_TX)
atmel_port->tx_done_mask = ATMEL_US_TXRDY;
else
atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;
--
2.35.1