The following series of patches add support for AM62 USB wrapper driver
and its corresponding bindings.
changes since v3:
- Removed the VBUS_VALID interrupt servicing as mode valid bit
need not be switched based on the connect/disconnect event.
The mode valid bit is being set during probe and cleared
during remove
- As VBUS_VALID interrupt is not being used, removed the interrupts
property from the bindings. As there is change in the dt-bindings
I did not pick the reviewed-by tags from the earlier version of
the series.
changes since v2:
- Removed the implementation of detecting the role from the wrapper
driver and moved the implementation to using linux,extcon-usb-gpio
driver for role detection.
- Updated the binding documentation and example to reflect the same.
changes since v1:
- Fixed the error with dev_pm_ops uninitialization, in patch 2.
This was reported by kernel test bot
- In patch 1, made correction in grammer of clocks property description
and added maxItems in the interrupts property based on comments
received from Roger
- In patch 1, corrected the title, fixed the description of
ti,syscon-phy-pll-refclk, added pattern properties and child node
in the example based on the comments from Krzysztof.
Aswath Govindraju (2):
dt-bindings: usb: Add documentation for AM62 USB Wrapper module
drivers: usb: dwc3: Add AM62 USB wrapper driver
.../devicetree/bindings/usb/ti,am62-usb.yaml | 103 ++++++
drivers/usb/dwc3/Kconfig | 9 +
drivers/usb/dwc3/Makefile | 1 +
drivers/usb/dwc3/dwc3-am62.c | 332 ++++++++++++++++++
4 files changed, 445 insertions(+)
create mode 100644 Documentation/devicetree/bindings/usb/ti,am62-usb.yaml
create mode 100644 drivers/usb/dwc3/dwc3-am62.c
--
2.17.1