Both lan8814_ptp_init() and lan8814_ptp_probe_once() are only used if
PTP and PHY timestamping is enabed. Up until now the probe function just
returns early, if they are not needed. But we need the
phy_package_init_once() functionality for the coma mode GPIO setup. Move
the check into the functions itself.
Signed-off-by: Michael Walle <[email protected]>
---
drivers/net/phy/micrel.c | 12 ++++++++----
1 file changed, 8 insertions(+), 4 deletions(-)
diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index 96840695debd..b981c5eaac33 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c
@@ -2729,6 +2729,10 @@ static void lan8814_ptp_init(struct phy_device *phydev)
struct kszphy_ptp_priv *ptp_priv = &priv->ptp_priv;
u32 temp;
+ if (!IS_ENABLED(CONFIG_PTP_1588_CLOCK) ||
+ !IS_ENABLED(CONFIG_NETWORK_PHY_TIMESTAMPING))
+ return;
+
lanphy_write_page_reg(phydev, 5, TSU_HARD_RESET, TSU_HARD_RESET_);
temp = lanphy_read_page_reg(phydev, 5, PTP_TX_MOD);
@@ -2767,6 +2771,10 @@ static int lan8814_ptp_probe_once(struct phy_device *phydev)
{
struct lan8814_shared_priv *shared = phydev->shared->priv;
+ if (!IS_ENABLED(CONFIG_PTP_1588_CLOCK) ||
+ !IS_ENABLED(CONFIG_NETWORK_PHY_TIMESTAMPING))
+ return 0;
+
/* Initialise shared lock for clock*/
mutex_init(&shared->shared_lock);
@@ -2843,10 +2851,6 @@ static int lan8814_probe(struct phy_device *phydev)
phydev->priv = priv;
- if (!IS_ENABLED(CONFIG_PTP_1588_CLOCK) ||
- !IS_ENABLED(CONFIG_NETWORK_PHY_TIMESTAMPING))
- return 0;
-
/* Strap-in value for PHY address, below register read gives starting
* phy address value
*/
--
2.30.2