Currently, intel_speed_mode_2500() redundantly fix-up phy_interface to
PHY_INTERFACE_MODE_SGMII if the underlying controller is in 1000Mbps
SGMII mode. The value of phy_interface has been initialized earlier.
This patch removes such redundancy to prepare for setting 1000BASE-X
mode for certain hardware platform configuration.
Also update the intel_mgbe_common_data() to include 1000BASE-X setup.
Signed-off-by: Ong Boon Leong <[email protected]>
---
drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c
index 38fe77d1035..675dfb89b76 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c
@@ -251,7 +251,6 @@ static void intel_speed_mode_2500(struct net_device *ndev, void *intel_data)
priv->plat->mdio_bus_data->xpcs_an_inband = false;
} else {
priv->plat->max_speed = 1000;
- priv->plat->phy_interface = PHY_INTERFACE_MODE_SGMII;
priv->plat->mdio_bus_data->xpcs_an_inband = true;
}
}
@@ -562,7 +561,8 @@ static int intel_mgbe_common_data(struct pci_dev *pdev,
plat->vlan_fail_q = plat->rx_queues_to_use - 1;
/* Intel mgbe SGMII interface uses pcs-xcps */
- if (plat->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+ if (plat->phy_interface == PHY_INTERFACE_MODE_SGMII ||
+ plat->phy_interface == PHY_INTERFACE_MODE_1000BASEX) {
plat->mdio_bus_data->has_xpcs = true;
plat->mdio_bus_data->xpcs_an_inband = true;
}
--
2.25.1