The state of the device is saved during pci_pm_suspend_noirq(), if it
has not already been saved, regardless of the skip_bus_pm flag value. So
skip_bus_pm check is removed before saving the device state.
Signed-off-by: Rajvi Jingar <[email protected]>
Reviewed-by: Rafael J. Wysocki <[email protected]>
---
v1->v2: no change
---
drivers/pci/pci-driver.c | 18 ++++++------------
1 file changed, 6 insertions(+), 12 deletions(-)
diff --git a/drivers/pci/pci-driver.c b/drivers/pci/pci-driver.c
index 49238ddd39ee..1f64de3e5280 100644
--- a/drivers/pci/pci-driver.c
+++ b/drivers/pci/pci-driver.c
@@ -867,20 +867,14 @@ static int pci_pm_suspend_noirq(struct device *dev)
}
}
- if (pci_dev->skip_bus_pm) {
+ if (!pci_dev->state_saved) {
+ pci_save_state(pci_dev);
/*
- * Either the device is a bridge with a child in D0 below it, or
- * the function is running for the second time in a row without
- * going through full resume, which is possible only during
- * suspend-to-idle in a spurious wakeup case. The device should
- * be in D0 at this point, but if it is a bridge, it may be
- * necessary to save its state.
+ * If the device is a bridge with a child in D0 below it, it needs to
+ * stay in D0, so check skip_bus_pm to avoid putting it into a
+ * low-power state in that case.
*/
- if (!pci_dev->state_saved)
- pci_save_state(pci_dev);
- } else if (!pci_dev->state_saved) {
- pci_save_state(pci_dev);
- if (pci_power_manageable(pci_dev))
+ if (!pci_dev->skip_bus_pm && pci_power_manageable(pci_dev))
pci_prepare_to_sleep(pci_dev);
}
--
2.25.1