The PHY interrupt (INT_N) pin is connected to IRQ2 and IRQ3 for ETH0
and ETH1 respectively.
Signed-off-by: Lad Prabhakar <[email protected]>
---
v2->v3
* Included irqc-rzg2l.h header
v1->v2
* Used macros of IRQ numbers
---
arch/arm64/boot/dts/renesas/rzg2l-smarc-som.dtsi | 11 +++++++++--
1 file changed, 9 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/renesas/rzg2l-smarc-som.dtsi b/arch/arm64/boot/dts/renesas/rzg2l-smarc-som.dtsi
index 9410796c8ad6..c4faff092380 100644
--- a/arch/arm64/boot/dts/renesas/rzg2l-smarc-som.dtsi
+++ b/arch/arm64/boot/dts/renesas/rzg2l-smarc-som.dtsi
@@ -6,6 +6,7 @@
*/
#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/interrupt-controller/irqc-rzg2l.h>
#include <dt-bindings/pinctrl/rzg2l-pinctrl.h>
/* SW1[2] should be at position 2/OFF to enable 64 GB eMMC */
@@ -94,6 +95,8 @@ phy0: ethernet-phy@7 {
compatible = "ethernet-phy-id0022.1640",
"ethernet-phy-ieee802.3-c22";
reg = <7>;
+ interrupt-parent = <&irqc>;
+ interrupts = <RZG2L_IRQ2 IRQ_TYPE_LEVEL_LOW>;
rxc-skew-psec = <2400>;
txc-skew-psec = <2400>;
rxdv-skew-psec = <0>;
@@ -120,6 +123,8 @@ phy1: ethernet-phy@7 {
compatible = "ethernet-phy-id0022.1640",
"ethernet-phy-ieee802.3-c22";
reg = <7>;
+ interrupt-parent = <&irqc>;
+ interrupts = <RZG2L_IRQ3 IRQ_TYPE_LEVEL_LOW>;
rxc-skew-psec = <2400>;
txc-skew-psec = <2400>;
rxdv-skew-psec = <0>;
@@ -171,7 +176,8 @@ eth0_pins: eth0 {
<RZG2L_PORT_PINMUX(25, 0, 1)>, /* ET0_RXD0 */
<RZG2L_PORT_PINMUX(25, 1, 1)>, /* ET0_RXD1 */
<RZG2L_PORT_PINMUX(26, 0, 1)>, /* ET0_RXD2 */
- <RZG2L_PORT_PINMUX(26, 1, 1)>; /* ET0_RXD3 */
+ <RZG2L_PORT_PINMUX(26, 1, 1)>, /* ET0_RXD3 */
+ <RZG2L_PORT_PINMUX(1, 0, 1)>; /* IRQ2 */
};
eth1_pins: eth1 {
@@ -189,7 +195,8 @@ eth1_pins: eth1 {
<RZG2L_PORT_PINMUX(34, 1, 1)>, /* ET1_RXD0 */
<RZG2L_PORT_PINMUX(35, 0, 1)>, /* ET1_RXD1 */
<RZG2L_PORT_PINMUX(35, 1, 1)>, /* ET1_RXD2 */
- <RZG2L_PORT_PINMUX(36, 0, 1)>; /* ET1_RXD3 */
+ <RZG2L_PORT_PINMUX(36, 0, 1)>, /* ET1_RXD3 */
+ <RZG2L_PORT_PINMUX(1, 1, 1)>; /* IRQ3 */
};
gpio-sd0-pwr-en-hog {
--
2.25.1
On Fri, Jul 22, 2022 at 5:12 PM Lad Prabhakar
<[email protected]> wrote:
> The PHY interrupt (INT_N) pin is connected to IRQ2 and IRQ3 for ETH0
> and ETH1 respectively.
>
> Signed-off-by: Lad Prabhakar <[email protected]>
> ---
> v2->v3
> * Included irqc-rzg2l.h header
Reviewed-by: Geert Uytterhoeven <[email protected]>
i.e. will queue in renesas-devel for v6.1.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds