Since commit 0166dc11be91 ("of: make CONFIG_OF user selectable"), it
is possible to test-build any driver which depends on OF on any
architecture by explicitly selecting OF. Therefore depending on
COMPILE_TEST as an alternative is no longer needed.
It is actually better to always build such drivers with OF enabled,
so that the test builds are closer to how each driver will actually be
built on its intended target. Building them without OF may not test
much as the compiler will optimize out potentially large parts of the
code. In the worst case, this could even pop false positive warnings.
Dropping COMPILE_TEST here improves the quality of our testing and
avoids wasting time on non-existent issues.
As a matter of fact, dropping the alternative dependency on
COMPILE_TEST allows removing preprocessor directives, which will
speed up the build.
Signed-off-by: Jean Delvare <[email protected]>
Cc: Daniel Hung-yu Wu <[email protected]>
Cc: Dmitry Torokhov <[email protected]>
---
drivers/input/misc/Kconfig | 2 +-
drivers/input/misc/atmel_captouch.c | 4 +---
2 files changed, 2 insertions(+), 4 deletions(-)
--- linux-5.19.orig/drivers/input/misc/Kconfig
+++ linux-5.19/drivers/input/misc/Kconfig
@@ -107,7 +107,7 @@ config INPUT_ATC260X_ONKEY
config INPUT_ATMEL_CAPTOUCH
tristate "Atmel Capacitive Touch Button Driver"
- depends on OF || COMPILE_TEST
+ depends on OF
depends on I2C
help
Say Y here if an Atmel Capacitive Touch Button device which
--- linux-5.19.orig/drivers/input/misc/atmel_captouch.c
+++ linux-5.19/drivers/input/misc/atmel_captouch.c
@@ -249,7 +249,6 @@ static int atmel_captouch_probe(struct i
return 0;
}
-#ifdef CONFIG_OF
static const struct of_device_id atmel_captouch_of_id[] = {
{
.compatible = "atmel,captouch",
@@ -257,7 +256,6 @@ static const struct of_device_id atmel_c
{ /* sentinel */ }
};
MODULE_DEVICE_TABLE(of, atmel_captouch_of_id);
-#endif
static const struct i2c_device_id atmel_captouch_id[] = {
{ "atmel_captouch", 0 },
@@ -270,7 +268,7 @@ static struct i2c_driver atmel_captouch_
.id_table = atmel_captouch_id,
.driver = {
.name = "atmel_captouch",
- .of_match_table = of_match_ptr(atmel_captouch_of_id),
+ .of_match_table = atmel_captouch_of_id,
},
};
module_i2c_driver(atmel_captouch_driver);
--
Jean Delvare
SUSE L3 Support