Up until now, the external MDIO controller frequency values relied
either on the default ones out of reset or on those setup by u-boot.
Let's just properly specify the MDC frequency in the DTS so that even
without u-boot's intervention Linux can drive the MDIO bus.
Fixes: 0420dde30a90 ("arm64: dts: ls208xa: add the external MDIO nodes")
Signed-off-by: Ioana Ciornei <[email protected]>
---
arch/arm64/boot/dts/freescale/fsl-ls208xa.dtsi | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls208xa.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls208xa.dtsi
index f1b9cc8714dc..348d9e3a9125 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls208xa.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls208xa.dtsi
@@ -532,6 +532,9 @@ emdio1: mdio@8b96000 {
little-endian;
#address-cells = <1>;
#size-cells = <0>;
+ clock-frequency = <2500000>;
+ clocks = <&clockgen QORIQ_CLK_PLATFORM_PLL
+ QORIQ_CLK_PLL_DIV(2)>;
status = "disabled";
};
@@ -541,6 +544,9 @@ emdio2: mdio@8b97000 {
little-endian;
#address-cells = <1>;
#size-cells = <0>;
+ clock-frequency = <2500000>;
+ clocks = <&clockgen QORIQ_CLK_PLATFORM_PLL
+ QORIQ_CLK_PLL_DIV(2)>;
status = "disabled";
};
--
2.25.1