Add snfi sample delay and read latency adjustment which can get
from dts property.
Signed-off-by: Xiangsheng Hou <[email protected]>
Reviewed-by: AngeloGioacchino Del Regno <[email protected]>
---
drivers/spi/spi-mtk-snfi.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/drivers/spi/spi-mtk-snfi.c b/drivers/spi/spi-mtk-snfi.c
index 85644308df23..f3f95eb37365 100644
--- a/drivers/spi/spi-mtk-snfi.c
+++ b/drivers/spi/spi-mtk-snfi.c
@@ -195,6 +195,8 @@
#define DATA_READ_MODE_X4 2
#define DATA_READ_MODE_DUAL 5
#define DATA_READ_MODE_QUAD 6
+#define DATA_READ_LATCH_LAT GENMASK(9, 8)
+#define DATA_READ_LATCH_LAT_S 8
#define PG_LOAD_CUSTOM_EN BIT(7)
#define DATARD_CUSTOM_EN BIT(6)
#define CS_DESELECT_CYC_S 0
@@ -205,6 +207,9 @@
#define SNF_DLY_CTL3 0x548
#define SFCK_SAM_DLY_S 0
+#define SFCK_SAM_DLY GENMASK(5, 0)
+#define SFCK_SAM_DLY_TOTAL 9
+#define SFCK_SAM_DLY_RANGE 47
#define SNF_STA_CTL1 0x550
#define CUS_PG_DONE BIT(28)
@@ -1368,6 +1373,8 @@ static int mtk_snand_probe(struct platform_device *pdev)
const struct of_device_id *dev_id;
struct spi_controller *ctlr;
struct mtk_snand *ms;
+ unsigned long spi_freq;
+ u32 val = 0;
int ret;
dev_id = of_match_node(mtk_snand_ids, np);
@@ -1446,6 +1453,19 @@ static int mtk_snand_probe(struct platform_device *pdev)
// switch to SNFI mode
nfi_write32(ms, SNF_CFG, SPI_MODE);
+ ret = of_property_read_u32(np, "rx-sample-delay-ns", &val);
+ if (!ret)
+ nfi_rmw32(ms, SNF_DLY_CTL3, SFCK_SAM_DLY,
+ val * SFCK_SAM_DLY_RANGE / SFCK_SAM_DLY_TOTAL);
+
+ ret = of_property_read_u32(np, "mediatek,rx-latch-latency-ns", &val);
+ if (!ret) {
+ spi_freq = clk_get_rate(ms->pad_clk);
+ val = DIV_ROUND_CLOSEST(val, NSEC_PER_SEC / spi_freq);
+ nfi_rmw32(ms, SNF_MISC_CTL, DATA_READ_LATCH_LAT,
+ val << DATA_READ_LATCH_LAT_S);
+ }
+
// setup an initial page format for ops matching page_cache_op template
// before ECC is called.
ret = mtk_snand_setup_pagefmt(ms, SZ_2K, SZ_64);
--
2.25.1