Add the rtc block on the first pmic to enable the rtc for sa8540p-ride.
Signed-off-by: Eric Chanudet <[email protected]>
Reviewed-by: Konrad Dybcio <[email protected]>
---
arch/arm64/boot/dts/qcom/sa8540p-pmics.dtsi | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sa8540p-pmics.dtsi b/arch/arm64/boot/dts/qcom/sa8540p-pmics.dtsi
index 34fc72896761..c9b8da43b237 100644
--- a/arch/arm64/boot/dts/qcom/sa8540p-pmics.dtsi
+++ b/arch/arm64/boot/dts/qcom/sa8540p-pmics.dtsi
@@ -13,6 +13,14 @@ pm8450a: pmic@0 {
#address-cells = <1>;
#size-cells = <0>;
+ rtc@6000 {
+ compatible = "qcom,pm8941-rtc";
+ reg = <0x6000>, <0x6100>;
+ reg-names = "rtc", "alarm";
+ interrupts = <0x0 0x61 0x1 IRQ_TYPE_NONE>;
+ wakeup-source;
+ };
+
pm8450a_gpios: gpio@c000 {
compatible = "qcom,pm8150-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
--
2.38.1