From: Yihang Li <[email protected]>
[ Upstream commit f58c89700630da6554b24fd3df293a24874c10c1 ]
Currently the driver sets the port invalid if one phy in the port is not
enabled, which may cause issues in expander situation. In directly attached
situation, if phy up doesn't occur in time when refreshing port id, the
port is incorrectly set to invalid which will also cause disk lost.
Therefore set a port invalid only if there are no devices attached to the
port.
Signed-off-by: Yihang Li <[email protected]>
Signed-off-by: Xiang Chen <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Martin K. Petersen <[email protected]>
Signed-off-by: Sasha Levin <[email protected]>
---
drivers/scsi/hisi_sas/hisi_sas_main.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/scsi/hisi_sas/hisi_sas_main.c b/drivers/scsi/hisi_sas/hisi_sas_main.c
index 1feca45384c7..e5b9229310a0 100644
--- a/drivers/scsi/hisi_sas/hisi_sas_main.c
+++ b/drivers/scsi/hisi_sas/hisi_sas_main.c
@@ -1408,7 +1408,7 @@ static void hisi_sas_refresh_port_id(struct hisi_hba *hisi_hba)
device->linkrate = phy->sas_phy.linkrate;
hisi_hba->hw->setup_itct(hisi_hba, sas_dev);
- } else
+ } else if (!port->port_attached)
port->id = 0xff;
}
}
--
2.35.1