GQSPI supports two chip select CS0 & CS1. Update the driver to
assert/de-assert the appropriate chip select as per the bits set in
qspi->cs_index_mask.
Signed-off-by: Amit Kumar Mahapatra <[email protected]>
---
drivers/spi/spi-zynqmp-gqspi.c | 21 +++++++++++++--------
1 file changed, 13 insertions(+), 8 deletions(-)
diff --git a/drivers/spi/spi-zynqmp-gqspi.c b/drivers/spi/spi-zynqmp-gqspi.c
index fb2ca9b90eab..3d2b92a88e8a 100644
--- a/drivers/spi/spi-zynqmp-gqspi.c
+++ b/drivers/spi/spi-zynqmp-gqspi.c
@@ -156,6 +156,9 @@
#define GQSPI_FREQ_100MHZ 100000000
#define GQSPI_FREQ_150MHZ 150000000
+#define GQSPI_SELECT_LOWER_CS BIT(0)
+#define GQSPI_SELECT_UPPER_CS BIT(1)
+
#define SPI_AUTOSUSPEND_TIMEOUT 3000
enum mode_type {GQSPI_MODE_IO, GQSPI_MODE_DMA};
@@ -467,15 +470,17 @@ static void zynqmp_qspi_chipselect(struct spi_device *qspi, bool is_high)
genfifoentry |= GQSPI_GENFIFO_MODE_SPI;
+ if (qspi->cs_index_mask & GQSPI_SELECT_UPPER_CS) {
+ zynqmp_gqspi_selectslave(xqspi,
+ GQSPI_SELECT_FLASH_CS_UPPER,
+ GQSPI_SELECT_FLASH_BUS_LOWER);
+ } else if (qspi->cs_index_mask & GQSPI_SELECT_LOWER_CS) {
+ zynqmp_gqspi_selectslave(xqspi,
+ GQSPI_SELECT_FLASH_CS_LOWER,
+ GQSPI_SELECT_FLASH_BUS_LOWER);
+ }
+ genfifoentry |= xqspi->genfifobus;
if (!is_high) {
- if (!spi_get_chipselect(qspi, 0)) {
- xqspi->genfifobus = GQSPI_GENFIFO_BUS_LOWER;
- xqspi->genfifocs = GQSPI_GENFIFO_CS_LOWER;
- } else {
- xqspi->genfifobus = GQSPI_GENFIFO_BUS_UPPER;
- xqspi->genfifocs = GQSPI_GENFIFO_CS_UPPER;
- }
- genfifoentry |= xqspi->genfifobus;
genfifoentry |= xqspi->genfifocs;
genfifoentry |= GQSPI_GENFIFO_CS_SETUP;
} else {
--
2.17.1